Your cart is empty.
Your cart is empty.Product Description
Sinoking 10T Recovery Winch Snatch Pulley Block
- 22000LB/10T Max load.
- Swivels open to accept line with no disassembly
- Reduces winch load and heat, helps increase winch pulling power
- Accept both wire and synthetic rope 3/8 in. ~ 1/2 in. diameter
- Grease injection hole
Breaking strength test
Pulley ancoring
You may need
Double/triple line rigging
Rodney Hermio Vupperschlitz
2025-09-02 16:13:28
I use it to change direction of pull when directional felling of trees, so they don't fall on my head! They seem well-built. I cannot verify that they can actually handle 22000 pounds, as a 1/2" rope would break well before that load. I use a 2000# rated rope come-a-long.
Harland L. Matthews
2025-07-30 15:54:53
Purchased this to use with a winch setup that I was adding to a car trailer. I used this once and it worked flawlessly!
Robin
2025-07-28 11:24:11
I use this to pull trees over on my property that are leaning toward my house. Tension them up to a good Arborist rope and cut it down. Its heavy so be prepared
zane halfaker
2025-06-18 13:34:58
Quality made and it works great. A must have for vehicle recovery.
Yes2God
2025-06-16 14:09:48
Pulley just as advertised. Rugged and held together with a big bolt instead of retaining rings. Much sturdier.
John Mullen
2025-04-22 11:01:00
Light weight well built
tacomuncher
2025-03-02 11:24:48
Very nice fit and finish. Rigged up on Cadillac hill after getting stuck in someone else’s ruts. Performed as expected. Also has zerk fitting.
Jeremy D.
2025-01-27 16:56:23
Very well built, but no directions were included about disassembly if need be. I would purchase again.
Recommended Products
$19.99
$ 9 .99 $9.99