Shopping Cart

Your cart is empty.

Your cart is empty.

SKB Roto-Molded 3U Shallow Rack (1SKB-R3S)

Free shipping on orders over $29.99

$194.99

$ 82 .99 $82.99

In Stock

1.Style:Rack


About this item

  • Roto-molded of Linear Low Density Polyethylene (LLDPE) for maximum strength & impact resistance
  • Available in 2U, 3U, 4U, and 6U sizes
  • Interlocking molded stacking bars
  • Gasket-sealed waterproof front & rear lids
  • Recessed twist latches


Available in 2U, 3U, 4U, and 6U sizes, SKB Shallow Racks are roto-molded of Polyethylene LLDPE for extra strength and durability. The exteriors feature SKB's recognizable bar design that signifies the rack unit size on the front and rear lids. Molded bars on top and bottom also provide interlocking capabilities allowing you to easily and securely stack them with SKB's Standard Roto Racks and Roto Rolling Racks, making transport even more convenient and secure. Lids include rubber gasket seals to keep water out. Other standard features include front and rear steel threaded rails and rack screws 10-32 thread, recessed steel Mil-Spec twist latches, flush carry handles, and non-slip rubber feet. All Shallow Racks are 10.7 deep from front rail to rear rail.


Rob
2025-09-04 12:31:27
Worked perfect for my Carvin B1500 amp - which is already very heavy by itself (35 Lbs). I had it in a wooden road case before and the whole thing was annoyingly heavy. This case is relatively light in comparison (10 Lbs) and makes it much easier to lug around that beast of an amp.
Pyrrho
2025-09-01 21:07:51
(3U) It is light weight, the latches work well, and it has no rattles or buzzes. Screws were included. These racks are made to stack and interlock. On the bottom the interlock feature is an indentation. I place it on top of a speaker cabinet that has a large strap type handle on top and the handle fits up into the middle indentation.
21 Truck
2025-08-19 15:51:56
I use the SKB 3U shallow rack for a Behringer X32 Rack mixer and (in a separate, identical rack) an uninterruptible power supply and drawer for an Apple Airport Router to complete the mixer package. The separate racks keep the weight manageable (the UPS is heavy) and make them more flexible to pack in the car/van. The stacked racks interlock to stay aligned and prevent sliding which is helpful both while in use and while being transported. The lids are deep enough to store a couple of short XLR cables or the IEC power cable for the X32 or other stuff. Overall, a well designed and well constructed rack case for your rack gear while in use and to effectively protect it from damage while being transported.
Zechariah Gober
2025-08-11 18:40:08
I like the rack case. Very lightweight and with it being shallow it’s not a pain to carry and get in or out of your car. I recommend it, especially for the bigger interfaces.
Dale
2025-05-14 16:18:06
Did not fit gear
Ryan Wilson
2025-04-20 16:10:05
Great rack for our livestream rig. It’s also lightweight and sturdy so we can carry it anywhere!
B Reid
2025-03-28 21:47:45
Got this to house mic pre-amp, compressor, power conditioner... added the stand and it now fits under my desk to be both out of the way & at a great angle to pop the cover off and plug-in for recording.
Seafood Licorice
2025-03-20 13:23:30
When I received the SKB and attempted to install my rackgear, two out of three units didn’t fit unless I reordered them in a certain way. They popped out of the frame. At first I thought it might be variances in my gear but I noticed a slight bend on the left rack rail. Ordered a replacement and everything fit so might have just got a bad one. Item is surely lightweight but definitely check for a proper fit if you’re using it for transport.
Noe Sanchez
2025-03-03 14:17:48
Exelente producto tal cual su descripción y llego un día antes
Eduardo Fernandez Pastor
2025-02-13 13:01:44
Muy buena calidad, no esperaba menos de SKB.Por poner pegas, lo de siempre. Los acabados podrían ser un poco más cuidados y el asa más cómoda.
John Warner
2025-01-29 16:30:20
I used to own the "X Rack" shallow model; this box is tad "deeper" (front to back) but with lids 7 rails on both sides MUCH stronger and more versatile!! Highly recommended!
J Hornet
2025-01-04 09:51:11
Good that this box has flanges on the back as well, for mounting a mains block. Solid construction but still quite light. If you need shelves, you'll need to get the shorter ones, as the box is not that deep
getCTOwned
2024-12-28 10:14:10
This is a good quality and pretty good looking 3U rack case.
Recommended Products

$149.99

$ 64 .99 $64.99

4.6
Select Option

$79.95

$ 36 .99 $36.99

4.9
Select Option

$367.91

$ 99 .00 $99.00

4.3
Select Option

$159.99

$ 66 .99 $66.99

5.0
Select Option

$499.99

$ 99 .00 $99.00

4.9
Select Option

$79.70

$ 34 .99 $34.99

4.9
Select Option