Your cart is empty.
Your cart is empty.These Skyjacker extended sway bar end links are designed to correct the angle of the sway bar once your vehicle has been lifted. They are manufactured from high-quality materials and use durable polyurethane bushings for maximum performance and durability. Available for your 4WD vehicle, the Skyjacker extended sway bar end links will help your suspension geometry throughout the entire travel.
Kasee Johnson
2025-08-06 10:41:30
After 8 years of strange noises from the suspension of my lifted Excursion, I finally have parts that work. I have worn through 4 sets of sway bar end links over the years - living on a dirt road is not gentle on vehicles. But finally finding, and ordering, the right part makes a huge difference! Excellent quality, easy to install. The ones I ordered for the front looked like they would work on the rear, too, so I ordered a second set. Perfect!
Breaker19
2025-07-04 14:55:06
Bolted right on the rear of a 2001 Super Duty, even though it is meant for the front. No modifications were made to the end links or the truck. I used the included shorter bolts on the frame side of the link (they are normally used for the sway bar side of the link) but had to run out and get two more bolts and flange nuts for the sway bar side of the link. The included longer bolts were too long and not fully threaded, so getting shorter bolts was easier than trimming and re-threading the long ones.
Steven Salfrank
2025-06-20 14:42:35
Lifted my F250 12 inches and needed longer sway bar ends. These worked great. Would also work for 8-10†lift as well
Brad
2025-06-06 10:04:36
Good product seems very sturdy. Bushings were a little tough to install with out a press. But fit good on my 02 f250 with an 8" lift
onetong8r
2025-05-15 11:40:14
Heavy duty. I have an 8" lift and they are a little long. Probably more appropriate for a 10" lift but they work well and came with everything needed.
Rogue
2025-03-11 18:15:13
Great product, you will need a vice to press in the bushings is the easiest way I have found. It was easy to install, the bolts and hardware included with the kit all were correct to install on the front of my 8 inch lifted 2001 F250 4x4.
Customer
2025-01-31 15:38:59
I installed these on a 2004 F250 Super Duty w/ 6" lift. Front end handling feels better after replacing these and the sway bar bushings.The included bolts were too short for the frame mounts. I purchased (2) 12mm x 1.75 120mm Bolts and used the included nylon locknuts.Also purchased 2 more 12mm Fender Washers to put in between the bushings and frame mounting block or else it will try to push the bushing sleeve out when tightening. I used silicon spray when assembling everything and white lithium on the metal/metal contact points.This was about 13$ in additional hardware costs which is unfortunate. Perhaps my experience can save someone time and frustration.
Nalla
2025-01-20 16:49:01
Just installed a week ago, so far it's holding good, had to modify bolt size, didn't installed it to a Jeep but to 2008 F250
Recommended Products
$153.71
$ 69 .99 $69.99