Your cart is empty.
Your cart is empty.Campbell
2025-07-28 18:10:18
Works great with my Ninja Thirsti. No need for me to spend more money on something that just has a different label on it. Very quick shipping! Will continue to buy these over and over again.
Gwen
2025-06-08 12:17:46
I bought this because the description said it was compatible. The cartridges are NOT compatible and item can’t be returned.
Andrew B. Marshall
2025-05-26 10:36:49
The canisters work very well with my Breville carbonation. My only issue with these CO2 canisters is that they don’t seem to be refillable or recyclable. They seem very well built and I hate to just throw them away…
American Liberty Logistics
2025-04-29 13:03:01
Cost saving using these in comparison to purchasing packaged units is substantial.
Shannon
2025-03-13 12:32:28
These work with the Ninja Thirsti. Have used three of them and no problems so far.
Mark D Bonney
2025-01-24 17:13:52
The bottles use similar colors and design to mimic Soda Stream cylinders. And their advertising claims to be compatible as well. But they're not. After screwing in, the cylinder doesn't "connect" to the Soda Stream connector - so, you a full intact bottle from sociology that needs a dispenser, and a perfectly good Soda Stream dispenser that only need a bottle of carbonation. But they don't work with each other, so their useless and you just wasted a chunk of change.
Tom
2025-01-16 12:09:37
The media could not be loaded.
Adrienne F
2024-12-01 18:56:25
I purchased this set to use with my Aarke Carbonator III, and overall, it works as expected. To complement this setup, I also bought a 20 lb CO2 Tank (New Aluminum CGA320 with a siphon tube), which I filled at a local store to ensure I could easily refill the smaller cylinders.However, I encountered some significant issues with these cylinders: 1. Burst Disk Failure: A few days after refilling, the burst disk failed under a pressure of around 1000 PSI. This is significantly below the tank's rated capacity of 250 BAR (3625.94 PSI). While replacing the burst disk should be straightforward, there's a major challenge...Lack of Customer Support: These cylinders are made in China, and there’s no contact information provided on the product or packaging. If you need spare parts or assistance, you’re essentially on your own. 2. The bottles themselves appear to be well-built, but the absence of accessible customer support diminishes their value. I’d be willing to pay more for cylinders backed by a reliable company with proper support in case of issues.Lastly, I noticed some complaints about compatibility with SodaStream systems. It’s important to note that using these cylinders requires basic knowledge about threaded versus unthreaded bottles. If you're not familiar with this, compatibility could be a challenge.
Recommended Products