Your cart is empty.
Your cart is empty.All Speed By Spectre products are designed to perform as good as they look using the highest quality materials and engineered for optimum fit and function.
jake n eggs
2025-08-19 12:47:11
Fit my 4.3 v6 262 motor with edelbrock 2111 intake manifold! I was worried it wouldn't fit, it does and I'm stoked! Oring seals tight, bolts are shiny, finish on all parts meets my initial inspection! No gasket needed? I'll find out! Saved some cash on this over the edelbrock version which was over $10 cheaper, so I took a gamble on this and I'm glad I did! Am I cheap? Not always. Did it work in my favor? You bet your radiator it did! Get it. You won't be disappointed, I know I'm not! And the oring seems like an easy find at Home Depot/lowes/hardware store.
Akula
2025-08-03 14:55:06
Added an A/C to a motor that did not have it. Previous owner had a water neck that pointed to the driver side of the block. I needed a neck to point to the front of the block. This works fine. No gasket needed because it uses an o ring to seal from the neck to the intake manifold. That seems to freak some people out but it works fine.
BOB GIBBONS
2025-06-28 15:48:19
Easy install
Maurice Chambers
2025-06-13 20:22:11
works well for what i wanted to do, nice and well made.
Kurt Pollard
2025-06-07 16:16:04
I need to route the hose in a weird position. This was the solution. Do ask me how the gasket set up works but it does. Great product
Kevin Morris
2025-05-20 18:42:21
Worked perfect for me to get the water neck pointing where I wanted it. I did have to drill out the bolt hols one size bigger to get it to fit my edelbrock performer rpm intake as the bolt hols didnt line up the greatest. I dont know if it was the manifold ot the water neck to blame as the old water neck had a tight fit also. Either way, it worked perfect for me and looks good too.
David Wade
2025-05-18 14:42:51
While adding fuel injection I found my existing radiator neck would not allow installation of a water temp sensor in the port next to the neck on the manifold. In looking at it I only needed the neck to be a couple more degrees clockwise to allow the sensor to be installed. Then I found this. Completely solved my issue I was able to clock the water neck out of the way of the sensor without causing an interruption in the flow to the radiator. In fact there in no kinks at all in my upper hose, and its almost like the angle I installed this water neck is more appropriate for the car.
Daddy Magnum
2025-05-03 12:12:42
Nice part. The taller profile allowed me to add a temp gauge to my Edelbrock Performer (2101) manifold. Easy install and no leaks... yet.
Luis
2025-04-20 13:57:14
Tiene buen acabado luce muy bien cumple con su función
Silent Syl
2025-04-11 11:45:45
I was sceptical at first, cause the O-ring is over the thermostat. But it seems to seal well. Perfect for my custom application.Time will tell the durability.
Dyno
2025-04-08 11:10:16
Good quality
Brian Beresford
2025-02-22 12:04:14
The product was exactly as displayed, no need for a gasket as the ring does the job. The delivery could have been a little quicker, maybe has to do with the COVID-19.
Marcellin St-Gelais
2025-02-17 21:27:22
tres satisfait merci
Recommended Products
$69.50
$ 30 .99 $30.99