Your cart is empty.
Your cart is empty.This Spectre Intake Coupler is a 4 inch to 4 inch 90 degree elbow. It comes with two stainless steel worm gear hose clamps. Use it to connect any 4 inch outside diameter component or air intake tube to a 4 inch outside diameter component or intake tube. The coupler is not recommended for turbo-charged/supercharged engines.
wtrks2e
2025-09-04 11:42:04
This worked great for an LS-Swap in a small engine bay.
J.moore
2025-08-21 14:07:58
Perfect, perfect perfect
Robris
2025-08-17 11:41:20
This elbow is "not" hard plastic. It is flexible material (rubber like) and fit and functioned just like we wanted. Used it to make our own cold air kit on an LS engine in a 1964 Chevy El Camino. The description states PVC and most think that is hard plastic, this is not. It is very flexible and can be trimmed if needed. I would not recommend using in boosted applications (per manufacture as well) as there apparently is not any reinforcement woven into the material.
Rey R.
2025-08-12 12:32:54
If you look close you can see that it is not equal length. This worked out great for getting my turbo inlet tube in just the right spot. It is a 90 both ways but there is about 1" difference in length depending on which way you put it.
Christopher Ence
2025-07-21 16:02:33
It fits so I have no complaints
Mathew
2025-07-17 15:43:24
Pretty tough non-silicone rubber coupling that fits extremely securely on 4 inch OD. Good Stuff!
David
2025-07-06 15:46:47
It replaces old part that got a big cut on i works great
Isaac
2025-03-29 12:16:49
Truth that they are soft and could use some reinforced material and maybe just me, they seem to slightly harden once heated then soften once cooled. But only true 90 with short snout to fit tight areas. This is on Chevys TBSS stock throttle body.
mr mud
2025-03-16 16:11:21
I needed a tight radius elbow for my LS swap. They are good quality and worked awesom. I would buy them again.
Dan
2025-02-23 16:41:11
Good quality partExcellent for tight/clearance fitmentHighly recommend
Bill Gibson
2025-02-15 11:39:19
Very good quality
Dyllon
2025-02-04 10:37:23
This elbow worked perfect after wasting my time and money on others. I have an Ls swapped 240 sx with a Holley ultra low intake. The throttle body is 4†away from my rad. This 4†elbow was able to stay 4†diameter and 3/4†off the rad. Definitely worth it.
andy
2025-01-15 16:43:04
definitely a little flimsy, probably wouldnt handle boost, but it looks nice, and works fine for my N/A intake
Recommended Products
$99.99
$ 42 .99 $42.99
$18.99
$ 8 .99 $8.99