Your cart is empty.
Your cart is empty.Spicer U-joint Kit, 1310 Series. Spicer parts are engineered to ensure longer life for vehicles in a wide variety of applications. That's because Spicer parts are manufactured to the exact standards and specifications as Original Equipment parts.
Philip L Ball
2025-09-05 11:21:24
Not sure if they changed the packaging since some of the earlier reviews but mine came with the clips in bags and instructions on those bags. I bought the non greaseable lifetime U joint. It comes pre-loaded with grease in the precise amounts needed to be balanced on all 4 corners. Also it doesn't have holes drilled in for grease nipples so its considered stronger than the greaseable kind. In any case you must not mix up the caps because you can end up moving grease around (hard to imagine that being a problem but I think it can result in seal damage) and you must not add any grease either for the same reason. The different colors for the clips are explained on the bags but they have different thicknesses. Copper colored are standard thickness, the thicker ones are there if you need to take up extra space to prevent the U-joint from having play, and the instructions also tell you to use those in pairs so the U joint is always perfectly centered in the yolk.As far as fitment goes make sure to check your specific application. Older fords that you think use a 1310 U joint actually used a 1310BC - two of the bearing caps are 1310 size and the other two are 1330 size. So make sure youre very clear which size U joint you need and measure cap sizes if needed.I did install with a hammer and impact sockets - but this can be a problem - especially with aluminum driveshafts because you can bend the ears and create binding in the U joint. You're supposed to use a press either a bench top hydraulic press or the heavy duty C clamp style U joint tool.
INTELLECTUAL GENIUS
2025-08-17 13:07:30
Bought this for my 2004 Jeep Grand Cherokee All Wheel Drive (Vin J). Modeled after factory perfect fit for the u-joint from rear driveline to differential. I did spend the few extra $ for the grease fitting. Amazon was about $10 cheaper than my local parts store on the same u-joint. This new part solved, the unidentifiable hum and low grade grinding, along with the occasional clank..... Used my ball joint press to make easier work of removal and replacement. Would buy again and highly recommend the Spicer brand.
DFOX97
2025-07-03 11:51:50
No issues. All found satisfactory, easy install.. A++
Zoe R
2025-06-14 18:59:39
I used two of these on the rear driveshaft on a 2000 Jeep Cherokee that I use on a mail route. I pumped some extra grease into the first one I installed and cracked one of the white plastic caps when installing it. Then....I read the instructions that came with the u-joint. DON'T ADD ANY EXTRA GREASE it said....very clearly. Oh, well....read and learn.Also....it might be smart to rent a ball joint press to install these into the driveshaft. I used a socket and a big hammer....but I think that there has to be a more....gentle way to do the job. I got the job done....and the Jeep doesn't feel like it's going to vibrate apart when I hit 57 mph anymore....but....I can't help but think that the next time I do the job it'll go a lot easier. You get an assortment of three different kinds of clips, too....I don't know if I used the right ones....but they seemed to seat OK so I'll convince myself that I did it right.These are good joints. Don't grease them....and rent a ball joint press....and it should go fine.It's easy to get the rear driveshaft off on a 2000 Cherokee, too.
Trey
2025-06-01 11:48:20
Installed on 2000 Jeep Cherokee 4.0l
MudDan
2025-05-20 19:40:40
I purchased these u-joints to replace the ones on the driveshaft of my 2000 Jeep Wrangler. Although the fitment chart says they will not fit my application, I made accurate measurements and came to the conclusion that these u-joints were an exact match.Per my measurements, I found the copper colored clips were the thinnest, and I used them to install my new joints.These parts came in on time, were very affordable, and in good shape. I have had a few of these joints, along with other Spicer joints and I feel they outperform some of the others I have tried from the typical auto parts store. These joints are cheaper, but yet more durable and reliable in my opinion. Ive never had a Spicer come in with a defect yet, the last duralast joint I bought was .040" too big and caused me to cause damage to my equipment since I thought it was my equipment that was at fault.
Gabriel
2025-05-11 17:07:47
Quit shooting grease all over your undercarriage and get these, they're better anyway.
David Kieras
2025-02-14 21:44:59
Well, these u-joints sure removed all the slop in my 2000 Jeep Wrangler Sahara drive shaft, and they allow me to frequently grease them. They seem very well made...but what did you expect from Spicer other than good quality? The only downside to these u-joints is that the installation instructions are very limited. Specifically, you are provided ten different clips but no explanation as to which are to be used in which situation. With a micrometer, i did measure that the gold were thinner than the grey, which were thinner than the green. And the tenth seemingly "incomplete" clip is to allow room for the zerk fitting on the greasable side of the joint. Had these details been included in the instructions, I think i would have given it five stars for the quality I perceived. Time will tell the longevity of the product...Also consider buying the Spicer (Precision Gear 2-70-18X U-Joint Strap Kit) with this, since proper maintenance requires replacements of the bolts/straps when the u-joints are replaced.
Juan Alejandro Polanco Cruz
2025-02-11 19:13:17
Excelente calidad como se espera de Spicer, quedaron sin problemas en la flecha delantera de mi XJ Cherokee 1995.
Roger Wait
2025-02-09 17:37:37
Pleased with this purchase, many thanks.
M
2025-02-05 10:08:19
As a Canadian i highly recommend this product as it is an upgrade to the original u joint from my tj. The most important is the bronze retaining clip which means it is more resilient to rust. A metal retaining clip will rust into your driveshaft after a fee winters. Making servicing a major pain because the metal once rusted dont come out easily....Major pain!
francisco r.
2025-01-29 13:55:23
es la medida para mi jeep tj 2000 buena marca duradera
Linda Blackie
2025-01-28 16:42:07
I was impressed with how perfectly these were assembled and greased. Installation was straightforward. Perfect fit.
Recommended Products
$20.48
$ 8 .99 $8.99