Your cart is empty.
Your cart is empty.Standard Motor Products GV3 PCV Valve Grommet
STEVE C.
2025-08-20 11:48:27
I used this Windsor part on my Cleveland. Cleveland has a 45 degree fitting and Windsor has a 90 degree. They are interchangeable with the correct cap and gasket.
chris9595
2025-06-28 13:54:34
The shop was able to install while doing the cover gasket replacement at no extra charge. Yay!
StLouis_1990
2025-06-25 11:54:55
Get the right grommet and it fits perfectly. I
Customer
2025-05-30 10:21:00
Works but a little loose. Not sure if the grommets where different or the fitting 🤔. Its on the engine. Hopefully it will tighten up a bit with a little use.
Customer
2025-05-12 15:06:44
Was exactly what I needed
parker
2025-04-13 13:02:40
Not a valve
Joe G.
2025-03-03 16:30:18
This didn't fit even though it was listed as fitting a 1973 Ford 351 (mine's a Cleveland-Windsor might be a different story) both here and at the "Stone car" site. The part does seem well made and I've had good luck in the past with other Standard Motor items.
Cliente
2025-01-21 16:13:57
this part does not fit my car. my cars part twists and locks and this part doesn't. its worthless junk.
Recommended Products
