Your cart is empty.
Your cart is empty.Standard Motor Products, Inc. - Condenser Ign (FD-75T)
Anita Hartling
2025-08-04 09:27:27
Worked as discribe
Don Roberts
2025-06-29 10:28:13
I have not used it yet, but it tastes good.
david malmsten
2025-06-11 14:10:48
I bought a new condenser from a John Deere dealer to replace a very old one, along with new points, rotor, cap, wires, plugs, & distributor shaft bushing. My tractor ran poorly and misfired constantly after replacing everything. Hours of troubleshooting revealed no certain fault. I ordered a Standard FD75T condenser even though my made in china Deere brand condenser tested fine at .27 microfarads. The Standard condenser I received is made in Mexico despite the listing saying made in china. It tested at .21 microfarads. I did not have much hope of improvement since everything in the ignition system was already replaced. Incredibly the engine fired right up and ran like a top after installing this condenser! I suspect the dielectric material was breaking down in the chinese condenser causing an intermittent misfire. This insulation breakdown would not show up on a capacitance test. Good luck with your ignition problem.
diego
2025-05-26 12:41:12
Awesome.
Don P. Jones
2025-04-16 17:49:52
Worked for my Bosch 019 distributor. Liked the fact that the mounting clamp is not secured to the condenser so you can adjust it as needed.
johnmiles
2025-03-12 11:49:05
Everything was perfect fast delivery and worked great
Customer
2025-01-30 15:52:26
exactly what I needed
Recommended Products
