Your cart is empty.
Your cart is empty.Instructions: 1. Make sure to operate with power off before install. 2. Before connect wire, please disassemble the screw with screwdriver and tigten the screw after connected wire. (Note: Please connect correctly the wires of earth wire, naught wire, live wire according to the picture show on the page). Extension Cord Plug Replacement provides a convenient solution for an repair, only need to replace the male plug end instead of buying a new electrical cord. 3 Pack Straight Blade Replacement Plug Black. 15 Amp. 1800 Watts. 110-125 Volt. 2Pole, 3Wire.
RManuel
2025-09-03 14:11:40
The room inside the plug is a little tight when terminating the wires but with a little practice, it all fits just fine. Very snug when you try to insert it back in the outer cover. TIP #1: remember to slide the outer cover over the wire first or you'll be terminating your wires twice :) TIP#2: when trying to insert the little screw to secure the cover, use some channel locks to squeeze the two pieces together and securing the tiny screw will be much easier. Very sturdy, and they look great when finished.
Craig Saunders
2025-08-07 16:52:19
Used these to replace the plug on an electric heater that I leave on quite a bit in the winter under my computer desk. The old plug would get hot and head up the cord leading up to it. After cutting the wires and installing the new plug, it no longer had an issue with the wire heating up. The inner screws along with the one outer screw are very very easy to use. The connections are also very isolated from each other preventing arcing within the plug. I used silicon rubber to fill the inside after installing and before screwing the cap on to help prevent corrosion and make it water tight.
alison clanton
2025-06-18 12:47:53
Quality is good but just too large for a small steam mop
Jeff
2025-06-17 19:26:18
Items as described.
V. Simon
2025-05-25 18:20:10
If you are not absolutely sure that you know how to properly wire each of the three cord conductors to its proper terminal, this isn’t the plug for you. The connection screws are not color coded, although there are tiny inscriptions on the plastic body that identify the white and green contacts.The terminal screws are tiny, and the plug is tiny and fussy to wire and assemble. If you have done this job before, then you will be okay.I suggest that you test your completed work with a 3-light outlet tester just to be sure that you haven’t cross-wired it.
Joseph Khoury
2025-03-26 16:19:44
Excellent Price and Quality
DW Miller
2025-03-25 14:18:55
These work and are heavier and easier to wire up. Happy
CoastalGuy
2024-12-06 18:50:03
Unlike a lot of repair plugs that are way oversize, these are more normal size and shape. The only thing I didn't like about them was that the case doesn't clamp down on the cord. All the tension goes thru the screws securing the wires to the terminals. So if someone trips on the cord, it's likely to yank the wires out.
Recommended Products
