Your cart is empty.
Your cart is empty. Made in the USA Suspa C16-02622 Gas Prop for Truck Caps and Campers
Set of Two Makes Replacements More Economical
Our C16-02622 Lift Supports Fit: Chevrolet Tracker 1990 - 1997, Geo Tracker 1990 - 1997, Suzuki Tracker 1990 - 1997. Hard Top Window.
Oleran
2025-08-30 16:18:20
These gas struts work just fine. When the struts on my Jason camper top went "mushy" and wouldn't hold up the rear panel, things got annoying. I found a number on the struts and did an internet search. These came up with a different number, but the length was correct. I ordered from Amazon and got them in 2 days. The old ones popped off fairly easily and these snapped into place without difficulty.They're working great!
Tomas
2025-08-23 15:32:49
Product worked as designed, was super easy to install, fit perfectly and seems to be great quality. Very pleased.
Christine Nordstrom
2025-08-20 16:13:39
Product is great. Unfortunately the window that we put this on was old and broke off because the gas spring was too strong for it. Just make sure the hatch you buy this for is secure enough to withstand a new spring.
Roland P.
2025-08-19 11:05:42
Good quality. Decent price. Exact fitment. Fast shipping.
Jon
2025-07-21 15:45:21
I used this for a 3x6 foot lid on a DIY enclosed raised garden bed. It's working perfectly so far. See attached photos of my project.I knocked one star off because they do not provide installation instructions, tips, or documentation of any kind.I spent two hours installing these gas springs in many different positions until I finally found the magic spot where they worked correctly. I would have greatly appreciated some documentation and placement tips for those of us who're not simply replacing existing gas springs.
jerry baum
2025-06-09 19:02:16
Very good quality will buy again
BILL M.
2025-05-31 12:51:22
I bought this to replace the struts on my F150 camper shell. The camper shell has a glass door that lifts up. It has been a number of years since the old struts have been in service. They needed replacing a few seasons ago. I knew to measure the extended length (from center of ball mounts) and the retracted length (center of ball mounts). I wasn't sure how to figure out the pounds of force. After surfing the net, I realized it depends on your application (yes, I already knew that). There were no part numbers on the old ones that helped. So I took a chance on these 28 lbs of force. I ordered these struts and they arrived with in a few days. When I installed them it around 30 degrees, a cold daytime temperature for the southeast. Installation was quick and straight forward. Just place a small screw driver under the metal clip a lightly pry it back. Place over ball mount and push toward ball. Remove screw driver and wiggle ball mount till it the clip locks into place. Each mount takes a few seconds to install. Note: most manufactures suggest installing struts with the gas cylinder on top (thicker end). Anyway they work great! The 28 lbs of force is more than enough. If your camper shell struts need replacing, this is a great choice.
L. Haas
2025-04-23 10:27:36
Perfect fit for my 2023 Polaris General FlipOut windshield for half the price of a polaris one.
Client d'
2025-04-09 12:12:54
Utilisation pour le remplacement de deux vérin de haillons d'un 4x4 B2500 Mazda fais le travail parfaitement
wizzard
2025-02-25 21:44:40
They did the trick. Works great
Doug Carnegie
2025-02-03 15:21:08
Delivery was prompt. Perfectly suited for my truck cap lift gate
mario Patenaude
2025-02-01 13:13:52
Support de porte
Johanne cote
2025-01-30 11:50:20
Pour camion vraiment bien
Recommended Products
$329.95
$ 99 .00 $99.00