Your cart is empty.
Your cart is empty.Specification: Model:T129215SU Voltage: DC 12V Current: 0.50AMP Fan Dimension (L x W x H): approx. 88mm * 88mm * 12mm Mounting holes distance: approx. 32mm* 32mm * 32mm (Center to Center) Power Connector: 4-Pin Header Applications: GeForce RTX 2070 SUPER ROG STRIX GeForce RTX 2080 SUPER ROG STRIX GeForce RTX 2080 ROG STRIX GeForce RTX 2080 Ti ROG STRIX Radeon RX 5600 XT ROG STRIX OC Radeon RX 5700 XT ROG STRIX OC
Tony
2025-08-18 10:40:45
Last fan on my Strix 2080 ti went bad and was wobbling like a boat on a rough sea. Thankfully the Strix 2000 series is fairly easy access to the fans, so it was a fairly easy job to replace them. Just make sure you have a very fine magnetic Phillips-Head driver, something from an ifixit set or such as you have to go between the blades to remove and replace the screws.Thee fans appear to be OEM to this SKU of cards and the part numbers matched up. My only issue was the cable seemed about a half inch longer at the end and I had to finagle it a bit to get the cover back on. So far the fans have been running smooth and quiet, even slightly quieter at full ramp speeds. Keeping my 2080 ti at about 74c-76c under heavy load while gaming.
Patrick
2025-08-15 16:45:08
The previous GPU fan had been making noise and one of the three fans was failing so replaced one of the three fans through Microcenter. Very expensive. Other fans began to make noise so this time we decided to replace the GPU entire 3-fan unit ourselves. Very easy to replace. And the new fans work as expected.
Clayton Bridges
2025-08-10 11:38:56
My GPU/computer started surging the fan speed, where my fans would increase and then decrease constantly. It was very annoying. Also, one of the fans, the middle one on my old GPU was visibly wobbly.So I ordered this to replace my fans on my 2080ti, unscrewed the fan shroud and the set of fans and replaced them, and it fixed my problem. Its been about a week or two so far, I will try to update if they dont last.But for $20, this is alot better than buying a new GPU
Matthew Quinn
2025-07-10 15:15:35
The fans appear to be a direct replacement for the factory fans. Unfortunately, they run at 100% all the time. I've gone through all the steps of completely uninstalling all drivers, utilities, etc. to attempt to reset this, but nothing works at all. I don't think they report their speed correctly as the RPM readouts are nonsense numbers like 15674314854348 rpm. I was really hoping this would let me keep using my 2 year old 2080ti, but it doesn't seem like this is the solution. I'm going to re-install the original fans and try only replacing the center fan next.
Rigamortiz
2025-06-30 10:02:39
Arrived on time in good condition. Fans fit perfectly and install was a snap. Currently they are running great and are nice and quiet. Since they were just installed I will have to post later on how long they last.
Taylor Bertrand
2025-03-06 13:35:08
Wiring does not fit perfectly inside GPU channel forcing some of the cable to stick out, which while aesthetically displeasing, is not a huge issue and doesn't seem to affect performance. Fan worked fine until after 2.5 weeks it started making a constant grinding noise on the middle fan at any speed.
KH
2025-01-20 15:22:03
Worked great, now my GPU works like new
Michael S.
2024-11-14 12:02:53
So far, the fans appear to be working correctly except when I look either at open hardware monitor or ASUS AI Suite 3. The fans appear to fluctuate RPM from 600rpm to 3157895 rpm (well beyond the actual fan range). The original fans had a much smaller range and looked similar to other fans in the system with that regard (other fans are in the graph). I looked at the fans visually and listen and they don't appear to be fluctuating. My guess is there is some type of logic error with the fans that cause them to miss report. I haven't played any games yet. It will be interesting to see if they work properly when under stress. I'll report back later if they don't. Otherwise, please assume all is well.
Recommended Products
