Your cart is empty.
Your cart is empty.Product Description
Product Parameter
2 Position 2 Way Solenoid Valve 2V025-08
- Voltage:DC24V
- Inlet = Outlet = 1/4"NPT
- Working Pressure Range:25-116Psi
- Working Temperature:32~140℉
- Operation Type: Internally Piloted Acting Type
PRODUCT FEATURE
High Frequency Guide
- Pure Copper High Precision Pilot Head Up To 5 Times/second Air Valve Precision, Smooth Without Stuttering.
Electrode
- Grounding Wires Can Prevent Static Electricity or Leakage on the Surface of the Equipment, Especially for High-power Appliances.
- Light on = Working.
Strong Sealing Performance
- High Heart Rate Sealing Ring, Self-moistening Sealing Rubber, Close to the Valve Spool Seamless, Strong Sealing Performance.
Simple Function Diagram
- In The Non-energized State, The Inlet And Outlet Are Closed.in The Energized State, The Inlet And Outlet Holes Open.
- Pay Attention to Check Whether the Components Are Damaged During Transportation Before Use, and then Install and Use.
- Please pay attention to whether the use environment meets the product requirements (such as pressure range, temperature range, voltage, etc.).
Andrey
2025-09-06 17:06:45
Must have for each owner of laser cutter machine
Tinkerman
2025-08-29 14:01:06
These work just as well and last just as long then much pricier ones I used for our projects.
DWG
2025-08-27 16:56:42
Purchased this to construct a temperature controller for a low-pressure steam heater. So far it has worked perfectly and with the PID it supplies the necessary heat in our production area. Tailonz products are well built and cost effective.
Ronald Rodriguez
2025-06-23 17:13:29
I got this to help with my air assist on a laser. After wiring it wouldn’t turn on so I thought it was my wiring. It was not after careful inspection. It was the unit that was broken. Power came in but the switch did not work. Replaced it for the pre wire one and that one worked well. Over all it’s good just test before fully assembling.
Roland Gassmann
2025-06-21 17:13:15
the valve has a small leak when closed. I did opened the valve and the rubber gasket is poor quality and dose not close competently. that where the leak is coming from.
PostMo Woods
2025-06-20 18:36:09
I'm using this as a trigger to run air to a pneumatic drill. For that purpose, it is performing very well. I haven't had to replace it and it's performed well over 200,000 times by now. I expect it might do a million plus cycles similar to other solenoids from this company. Recommended, though your mileage may vary if you have to hold it open for a long time or something like that, might get hot. I wouldn't necessarily think that would be a good idea, but for providing a puff of air, it's great. Total recommend.
Chains
2025-05-09 10:23:55
Been using this over 6 months on my semi in the open elements. Works great!
travis blackshear
2025-05-06 18:28:35
Silinode works but doesn’t tell you how to wire or hook leads up so trial and error a lot
Cliente de
2025-02-01 14:04:23
trabaja muy bien lo instale en las cornetas de aire
Maya D.
2025-01-30 14:29:15
dejo de funcionar al med de uso ya no cerraba se quedaba abierto todo el timpo
Recommended Products
$39.99
$ 18 .99 $18.99