Shopping Cart

Your cart is empty.

Your cart is empty.

TEMCo THA033 3/4' Conduit Punch and Die For Hydraulic Knock Out Driver

5.0 Write Review
Free shipping on orders over $29.99

$14.99

$ 7 .99 $7.99

In Stock

About this item

  • Conduit Fitting Size: 3/4", Actual Hole Size: 1.05"
  • Required Punching Force: 9 US Tons
  • Fits Draw Stud Size: TEMCo THA012, THA013, THA015 or any draw stud with a diameter of 0.430" (10.90mm) NOTE: This die set DOES NOT have threads.
  • Punching Thickness Capacity: 1/8" (11 ga) Steel, 1/16" Stainless Steel
  • Made of Hardened Tool Steel with Black Oxide Finish. Punches Materials: Steel, Stainless Steel, Brass, Copper, Aluminum (soft alloys only, not for use with 7075 or other super alloys), Fiberglass, Plastic and more. NOTE: No threads. Meant to be used with TEMCo draw stud or any 0.430" diameter draw stud with knurled nut.


Our punch dies are sized to conduit sizes, not actual hole sizes. Electricians use these sizes because conduits are measured by the inner diameter of the tube, not their outer diameter. That means, for example, a 1" punch die will correctly punch for a 1" conduit tube (which has an actual hole size of roughly 1.33"). We've provided you with a handy table below that shows the actual hole size produced by our punch die/conduit sizes in this set.
This set includes a single punch and die set. Punch die sizes are equal to conduit tube sizes. Can be used with TEMCo, Greenlee, or any other knock out punch set.