Your cart is empty.
Your cart is empty.Product Description
HIGH QUALITY BATHTUB SPLASH GUARD
- Suitable for bathtubs, sinks and other sanitary ware
- Shower splash guards are made of high-quality materials, safe, high temperature resistant, without unpleasant odors.
- Prevent internal water from overflowing and cause damage, and keep the external surface dry and safe.
Smooth surface is not damaging in any way
Premium Transparent thickened EVA plastic
3M super viscose fiber with strong adhesive
Installation Steps:
Fold the red paste part of the splash guard back to 90°
Tear off the sticker of the 3M adhesive surface
The splash guard can be glued at 90° right angle
Done
S Rafi
2025-09-05 11:29:19
Great product and uses 3M VHB tape, which is greatly known for its bonding strength. But the cover of the tape was slided during shipping which made some areas of the tape covered in dust.
Judy Tucker
2025-08-30 20:33:11
Cheap guard not worth what I payed..
Rachael Amick
2025-08-06 21:56:49
This is a great designed product that has helped greatly in stopping water leaking out of the shower by the curtain/if splashed in the corner. It has been used for about 6 months with no issues and was easy to install.
Chris_1200
2025-07-08 17:15:48
Brittle and the adhesive doesn’t work well.Went on easy enough. Upright part peeled itself off the wall within about 8 hours and wouldn’t re-stick. Tried to gently pull the bottom off, hoping to use some adhesive, and it shattered in my hand.Look for something more durable and with better reviews regarding the adhesive.They are nice and clear, though.
Customer
2025-06-09 16:08:56
The product does block most of the water. However some water does go under the adhesive and leak past. Did help make the leaking reduced but not 100%
@Finley_theaus
2025-05-14 10:21:21
Saw this on an instagram account and bought almost immediately. My 2 y.o. daughter loves to pour her water in cups and it was getting everywhere. This came and it prevents SO much water from being spilled out of the tub! It is VERY sticky and strong adhesion. It took a lot to bend the plastic back. SO much that I had to make sure this was what I was supposed to do since it felt like I was going to break it. Then it's a little bit of luck sticking it down on the tub since it's a corner, once you picked either the tub or wall, the other side would start sticking. Luckily I just aimed for the corners to line up as far back along the tub wall and it worked great!
Lea Sheppard
2025-05-01 20:56:21
The media could not be loaded.
Debra Whittemore
2025-04-05 10:47:46
seems to do the job of keeping water from splashing out of tub while taking a showerwhen installing this product it does not sit flush on at a 45 degree angleonly concelation is that it sticks to the walls of the tub even though it is not flush, only the edge is sticking
Liz
2025-04-01 12:54:52
New bathtub, but no doors, this helps keeping the water where it should go, in the tub.
Jacqueline
2025-01-24 16:43:48
Works well but I had to caulk the corner to stop water from going on floor. Does the trick and not hideous looking
Annonn
2025-01-21 14:45:05
I'm sure it will do the job, but its a lot thinner and flimsier than expected
Michael LaMarche
2024-11-27 15:09:31
plastic too thin
Recommended Products