Your cart is empty.
Your cart is empty.Product Description
Timpano Compact 4 Channel TPT500.4 Car Audio Amplifier – 4x 125 Watts at 2 Ohms – Mini Stereo 12 volts Full Range Class D Amp Bridgeable
Small Footprint Technology!
Timpano amplifiers raise power amplification to a new standard of quality and usability. The new line delivers the most innovative and powerful Brazilian technology in compact full range amplifiers on the market. Loaded with features, it provides an unsurpassed efficiency rate of 80-90% in a compact Class D full range amplifier.
- COMPACT DESIGN: Digital class D Brazilian technology allows this amplifier to have a small footprint by integrating a high-speed mosfet power supply with top of line transistors to ensure performance in a small heat sink without compromising performance. Dimensions: 3.93″ depth x 5.02″ width x 2″ height
- POWER: This amplifier is designed to run your stereo system with the power it needs to perform! 500 Watts maximum dynamic RMS power output of 4x 125 Watts at 2 Ohms per channel. Its high efficiency rate of 87% provides more power with less battery consumption.
- BRIDGEABLE: Double the power output to your speakers by bridging two channels. The minimum impedance of 4 Ohms per bridged channel at an output power of 2 x 225 Watts RMS
- TECHNOLOGY: A smart electronic 2-way protection circuit protects the amp if it gets too hot or if speakers fail to cause a short! Focusing in sound quality, a full range response of 10 to 24,000Hz was used to give the best sound reproduction on this tiny amplifier.
- FEATURES: Heavy Duty 10 Gauge power and speaker wire Inputs. Built-in crossover filters for easy tuning! Choose between a fixed HPF at 90Hz or LPF at 90Hz + 45Hz Bass Boost or just turn it FLAT and use your external crossover or DSP settings. It also includes Variable Gain Control. Level controls are not for adjusting volume. They adjust the amount of signal that is coming into the amplifier from your signal source.
Before Installing:
You must follow the instructions for the product’s installation and connections to assure optimal performance. If you have any questions, get in touch with us. Before using the amplifier, always follow these guidelines:
• Make sure the amplifier is switched off before adding or removing any connections. This prevents possible damage to the equipment connected to the amplifier; • Keep all cables as far away as possible from the ignition cables, electronic injection modules, and starter switch since they may cause noise interference; • Always use 100% Copper cables and good quality connectors. This assures the sound’s quality and fidelity; • To avoid damaging the cables, make sure that they do not touch sharp metal edges. Important: Use a fuse 12 inches away from the battery as a safety precaution
The power-rated data are based on equipment from the PRV Audio Group laboratory. Frequency reference of 1Khz with THD+N to ≤10% in impedances referring to the indicated in each measurement. The electronic components and the manufacturing process can present manufacturing variations, thus leading to a variation in the measurements made. This amplifier is designed to perform on music applications ( with speakers ), any load test ( resistant load ) is not recommended.
Customer
2025-08-14 10:58:57
Works excellent, fits behind the radio in the dash of my truck. Downside, it doesn't like heat, and if I blast the heat out of my dash vents, it will eventually start to cut in and out because the ducts run behind the factory deck. It's fine 99% of the time but be aware of this when picking a spot for it.
Tommy DeGrange
2025-08-11 12:37:38
It's small. I can't begin to express that. It's the whole reason I bought it. I needed a small amp for my old CJ 7 Jeep. At the price point I was very skeptical but not being made in China was a good thing.Install was straight forward max wire size is 10awg for anyone looking to purchase a wiring kit at the same time. I installed mine on the plastic air box under the dash (only available spot out of the weather). Performance is above expectations even more so considering the size and power rating on this unit. I'm not running a subwoofer only 2 6x9" speakers in the rear and 4 6-1/4" speakers in the front. If I was going to have a sub I would recommend stepping up to the 1000 watt unit (only slightly bigger based on dimensions given)I will update this after several weeks worth of driving. I'm getting ready for a road trip to the beach so it will be a great test of highway noise vs sound system.Update as of 9-15-24This thing is amazing. Wonderful sound quality and even with off road tires and no top or doors I can clearly hear my music blasting out of my speakers. My 4+ hour trip was fantastic with the sounds blasting from my speakers. Previously I would have the volume maxed out and still barely hear the music over the wind and tire noise. Not anymore now with this little unit I don't even hit 50% volume on the quietest of songs and typically only have it at 20-25% with most.I highly recommend this for anyone looking for a compact amp that will greatly increase the quality of their sound system.
Joe Clark
2025-07-26 15:59:53
I owned a car audio shop for 15 years. (mainly JL, Rockford Fosgate, Alpine) I can say with confidence this amp will impress you. It's tiny, super clean, doesn't draw much power, and will most likely be more than you'll ever need for a 4 channel setup. Take note the speaker wiring is odd, just do as the terminals are marked. Its the only 4 ch amp I've encountered which outputs are shared.
adam
2025-06-05 12:47:44
It hums quietly. Spend hours finding new grounds and wires and all sorts of crap, turns out the amp really is just crappy. Not only does it have a hum that doesn't go away, the back faceplate completely bows in when plugging in RCAs. Spend a little more.
Elijah
2025-04-24 15:38:53
Get the job done to be a small amplifier.I've purchased 3 of they're very powerful.I don't even think I have any.I'm turned up over quality.Good value sounds good. perfect size for a bike or car.
Long Mac
2025-04-18 20:03:41
The media could not be loaded.
Judith S. Shumway
2025-04-07 14:05:49
I really like how small it its. Crossover options are very limited, but for the size its nice that there is a LPF and HPF on all channels, even if they are both fixed at 90hz.Powers my Rockford Fosgate 6.5" component set, and both of my Earthquake SWS 6.5 woofs in the doors. Clear, minimal distortion.The best part is the size though, it's smaller then a thick sandwich on wonder bread. 3"W x 5"L x 2"H. I'll be buying another one to replace a larger, less powerful amp very soon.EDIT: Bought another amp 4/1/24. I decided to run each of my 100w subs on each channel of this new amp, bridged for absolute minimal distortion and obviously maximum output. And....rear channel is dead. No working. Ok, so checked all my connections, swapped the wire, not a peep. I went to maybe switch them around again and I noticed that when you hold the RCAs against the amp it would complete the connection and sound would cut in. Let go, cuts out. Its like when you had a bad headphone jack and had to hold it into the plug.Well I cant do that, when the amps under the backseat in my truck.Returning, hopefully the next one that comes is perfect like the first. Now I gotta dig up the box and packaging, at least the recycling didnt come this week. I had mega faith that the second amp would be fine but no dice. Fingers crossed. Will update.UPDATE #2: Replacement amp works well, all channels. Just like the first. Had to have it because the size is just perfect to fit in the space off the back wall under the back seat in my extended cab 2500. Both amps, equalizer, and all wiring fits nicely. Would buy again.Test as soon as you receive it.
Michael
2025-04-01 15:28:44
This was so easy to install under my dash, and makes a big difference in sound for my speakers
Etienne Germain
2025-02-10 17:00:44
Facile a instaler et performance extra
Mathtylica
2024-12-24 10:37:50
Very powerfull little amp with no distortion at high volumes. I bought 2, one for front & one for rear both bridged. There is a hissing sound at 0 volume that IS NOT from a ground loop or bad signal wires. I spent $200.00 to learn this. The noise isn't loud and goes away at any volume but not dead silent at 0 volume so it's a deal breaker for me.
Pops
2024-12-21 14:45:11
Pourquoi il n'a pas de plan de montage, je comprends pas le shema ont peu pas branché un fil négatif avec un fil positif ??
Recommended Products
$129.99
$ 56 .99 $56.99
$80.92
$ 32 .99 $32.99