Your cart is empty.
Your cart is empty.The included removable adapter allows the hopper to feed .50 caliber paintballs or if removed, feed .68 caliber paintballs. It’s perfect for players who are after a smaller size capacity and a paintball hopper that does not jam. (NOTE: Minimum feedneck diameter is 1 inch. Will not fit all .50 cal markers)
PNW BALLER
2025-09-01 10:55:25
Good little hopper. The lid is sturdy.
Acidsoup
2025-07-28 13:06:23
I wanted to have a smaller profile hopper, so I felt a 100 round capacity was the best option for me. The flip lid is solid, it loads goods, and just remember to take off all the screws to remove the feedneck inside to go from .50 to .68.
jeremy
2025-07-20 18:38:26
Wrong sized hopper. Only fits a .68 even though it says multi fit
Jm Hdez Coste
2025-07-03 13:04:31
A little bit wide it obstruct my dot sight
mike pluff
2025-05-29 17:52:10
I use it with my pump. It works well, it's a shake and bake. Feels solid, feedneck is a good size, no complaints here.
Jeffrey
2025-04-29 11:12:29
Holds paintballs, feeds great. Just make sure you.remove the insert if you're using .68s or you'll be surprised when they don't fit!
Matt K.
2025-03-27 14:23:59
This hopper is perfect for a pump gun. I ended up cutting it to sit as low as it could on my KP3 rig.
David
2025-01-12 11:44:48
I bought this to pair with a Valken Cobra Marker since it says it works with 50 or 68 cal. However the attachment point to the marker does not fit the Valken (or likely any other 50 cal). Apparently for 50 cal, it's intended for use was a conversion kit to convert 68 cal to 50 cal.
Recommended Products
