Your cart is empty.
Your cart is empty. INSTALLATION NOTES:
1.Insert bolt through the wheel, washer and training wheel arm.
2.Attach and tighten washer and nut, you will require two wrenches to tighten this propeily.
3.Remove rear axle nut from the bicycle wheel axle.
4.Insert axle though locking brace and fix the raised point to the bicycle frame ends .
5.Determine desired height of training wheels when attached the training wheels should have about 0.5-1cm (1/5 to 3/5in) space from the ground.
6.Tighten axle nut with adjustable wrench .
7.Repeat for another suide.
Specification:
✔ Material: Steel + Plastics + Rubber
✔Color: Blue ,Black, Red,White, Purple, Rose
✔Size: Wheel: 4.54 inch*4.54 inch*0.98 inch /11.5cm *11.5cm*2.5cm
✔Fit: 12inch Bicycles
Fizzle
2025-08-29 17:59:01
As described. Worked as should.
Sanam Lama
2025-08-07 15:47:13
I like it
Sara
2025-07-13 14:29:07
My son loves these training wheels, especially that they light up. It does not come with the nut to screw onto the bike. Additionally, they are not adjustable so you cannot lift these off the ground a bit, as I would've liked. They are on exactly the same level as the back wheel of our Huffy 12" bike.
Yair
2025-06-14 17:52:38
The kit arrived but it was missing nuts to lock the screws that hold the wheels.Got nuts from home depot M8x1.25 and spring washers.Overall looks quality and it is nice on the bicycles.
Thomas L. Woodring
2025-05-04 18:45:39
After purchasing the Hyper GoGo Cruiser 12 -Electric Kids Motorbike, we felt it best to order the suggested training wheels. These wheels come with no instruction's, just a lame drawing. These wheels are not designed for the GoGo Cruiser Electric Motorbike, videos on the installation of training wheels indicate this fact. When referring to product support, this is their recommendation, "Modify the training wheels or bike frame - If all else fails and the training wheels still don't fit, you may need to modify either the training wheels or the bike frame. Use a marker to carefully mark areas where drilling or cutting is needed.Note: Proceed with this step only if you're comfortable with making permanent changes to your equipment. Use appropriate tools like a drill or hacksaw to modify the marked areas. Exercise caution and ensure you're following safety guidelines." Of course, the seller isn't going to tell the buyer this before you make the purchase. We made it work with a few hours of modifications. Cutting, grinding, drilling and painting was required. Any seller that would neglect to inform the buyer of such issues before the purchase speaks volumes about the seller's lack of integrity.
M.E.P.
2025-03-23 12:25:15
Works perfectly on a child's 12 inch bike. Was a breeze to install. Adjustability is good.
SAyala
2025-03-16 17:01:16
I was able to assemble them fine, however, they don't really light up brightly and when I tested them before assembly I was able to get it to light up.
Carla
2025-02-04 17:04:39
These work great on my kid's 12" bike, except for a problem with the plastic chain guard on the bike that makes it impossible to adjust the training wheel as high as it needs to go. I cut a notch out of the plastic guard with a vibrating cutter tool and that resolved the issue. Again. it's not an issue with the product itself. They light up dimly when turning, which is neat, and the wheels seem very well made.
Recommended Products
