Your cart is empty.
Your cart is empty.Truetone's 1 Spot Pro CS6 pedalboard power brick boasts a sleek, low-profile design and powers any combination of pedals on your pedalboard. Its six fully-isolated power outlets drastically minimize the noise in your setup. Onboard you'll find two 9-volt outputs, two outputs switchable between 9 and 12 volts, and another two outputs that are switchable between 9 volts and 18 volts. You'll also get all the necessary cables and adapters. Individual toggle switches on the bottom of the power brick let you set up any combination of power values. That means you'll be able to power your existing pedals, and you'll also be covered when you get new pedals with different power requirements. The Truetone 1 Spot Pro CS6 pedalboard power supply is one of the most streamlined and capable powerhouses available today.
Craig Wilson
2025-09-04 14:54:50
Great power supply, very versatile and quiet. Fit perfectly under a Pedaltrain Metro 20
misterdister
2025-08-16 16:53:54
I downsized my board to a pedal train nano plus and my voodoolab pedal power 2 no longer fit. When mounted, it fits just as perfectly (tried velcro first but it made it a bit too high). The mounting instructions were very say but I still managed to drill one hole slightly off despite the template. I just drilled another hole right next to it to widen and problem solved. The screws don’t stick out at all on the front side, but I would recommending drilling through the Velcro so that screw head sticks out as much as the Velcro - very small amount- and it’s then even surface.Power seems to work great and came with all the cables I needed. Love it!
BotFixer
2025-07-27 16:20:17
Clean power supply, with electrically isolated plugs (no shared grounds or 9-volt power rails), lightweight, and most important for me: the LOWEST PROFILE (just under 1.25" tall) of any isolated power supply so it can fit UNDER a slanted wooden pedal board.I have an old Gator pedal board with custom tote bag (model GPT-PWR) and a power supply mounted underneath -- the Gator 8-port G-BUS-8 (). One day my pedal chain started sounded super hissy -- tons of high-pitched white noise. I eventually diagnosed that it was the power supply that was failing, not the pedals (had to disconnect and check each pedal on its own with a 9-volt battery).I did a ton of web searches for high-quality isolated power supplies and as far as I can tell this is the thinnest one made. Yes, it only has 6 output ports whereas the G-BUS-8 has 8. But if you have more than 6 pedals you can get a daisy chain cable and run several low-power pedals off one of the two 500 mA outputs. For example, here's a 3-to-1 cable (), and here's a 5-to-1 cable (). Yes, using a daisy chain cable defeats the purpose of an isolated power supply for the pedals that are chained together -- I'm just saying, if you need more than 6 pedals powered with the CS6, there's a simple way to do it.Finally, there is no obvious way to attach this thing underneath a wooden pedal board with screws -- the installation video on the Truetone web site shows how to do it for thin metal only. I decided since the unit is so light (1.3 lbs) I would try using velcro strips. I put 3 strips of hook velcro across the top of the CS6, with matching loop strips underneath the board, and it seems VERY secure under there.
High Snows
2025-06-14 14:51:36
Wanted to get rid of the HX Stomp brick. Used a Voodoo Labs current doubler with center negative polarity to combine the two 500ma outlets into one input to the HX. Plenty of additional power for remainder of my small board. Have room for an additional pedal on dedicated line, and could daisy chain for more. Well thought out supply lines of various lengths. Great temple for easy drill and mount with no brackets needed. No noise. Solid value for money.
RandomNerdGuy
2025-06-11 18:04:40
I use this under my on-stage mini pedalboard and it works OK. The build is pro quality and it works fine, but I need several more outputs for my mini pedal rig, so I have to daisychain a few pedals, which defeats the purpose of having the fancy supply. I mounted it with low profile dual lock and it holds well, but it has to cover a few of the cable-routing slots when mounted and makes it hard to route the cables cleanly on my particular board.Overall, it's a great compromise between pro quality and a tiny form factor. I can't use larger supplies under this tiny board and this one was recommended, but it wasn't made specifically for my board. Good enough. Will probably last years.
Customer
2025-06-10 12:07:05
Perfect power supply, with zero noise. Build quality is excellent and comes with a variety of different length cables and adapters. Ideal for a small pedalboard.
Jp
2025-05-21 17:59:24
Always a great choice. Works very well!
Nic
2025-05-12 13:57:28
Since I haven't had it for a long time, I'm not certain about longevity, but I do think this works well, is sturdy and doesn't have a wall wart power supply. It does mount under a metro pedaltrain 24" flat pedal board though, but just barely. It also didn't come with brackets, so to mount it you'd need some brackets of your own, or just zip-tie it. I like that it has toggles for 9-18V. so I can flex it out.
LRA
2025-03-05 17:35:30
The power in my apartment building is not very clean and there was always an annoying hum even when I practiced with a clean signal through a loop station. As I needed to power only a couple of pedals, I tried a few cheaper power supplies (2x Boss PSAs, a 1-spot combo pack (the one with the daisy chain)) and they just couldn't filter out the hum.Upgrading to this one was definitely a great choice and I don't regret. It's VERY quiet, compact (fits under the pedal board) and sturdy. If you're unsure about upgrading because of the price tag, I can share that, at least in my case, spending money on a good guitar and pedals, to have the joy of playing ruined by noise was very upsetting.I 100% recommend this.
Enrique Millan
2025-02-23 16:44:23
La verdad me gustó mucho tiene varios cables para la conexión, y elimina el ruido muy contento con la compra
A.Lee
2025-02-03 15:31:01
I bought the One Spot CS6 to upgrade from an un-isolated multi-output power supply. I'm very happy with the low profile, light weight and quiet operation of this unit. I also like it's ability to power additional pedals with a daisy chain. It makes an audible difference if you've been using sub-standard power supplies and gives you confidence that it won't run out of "grunt" when you need it.
Joan Tuareg Chávez Medina
2024-12-23 20:08:15
Simplemente el mejor, lo instale y me olvide de que existe, justo lo que necesitas de una fuente de poder
Eric G.
2024-12-13 15:56:09
I purchased this power supply to get rid of a noisy echo pedal and it worked perfectly. Isolated power source with no or near no background noise when supplying multiple pedals from the same board. A great buy and value for its price. Note that it comes with a lot of accessory that should suit most of stompboxes...
Recommended Products
