Your cart is empty.
Your cart is empty.Product Description
WiFi Smart Energy Meter,take command of your energy use.
Data Tests
- For 80A-200A CT item, Real time monitor total current, power and KWh , and also show A, B, C each phase voltage , current, power and KWh consumptionelectric stastic , it can record hourly ,daily,monthly and yearly power consumped KWh value for Total and each phase separately.
Wide range of applications
PC321-TY helps you monitor the power consumption oftheequipment,and can also measure voltage, current, powerfactorand active power.
Installation Instruction
The Power Clamp has a mounting bracket for mounting purposes.
1. Use the mounting bracket as template to mark the two holes on the wall for installing screws.
2. Screw the mounting bracket onto the wall according to marked location. Install wall plugs if necessary.
3. Locate the hooks of the mounting bracket and line up the hooks with the mounting holes on the Power Clamp. Fit the hooks into the mounting holes as the picture below. Installation is now completed.
Attach both ends of the Current Transformer Cables first like the picture shown below. Then spinning the waterproof latch clockwise until both ends have been tightened and secured.
Open the clamp as shown below. Apply it on the electric meter cable. The arrow on the clamp should face to the correct direction of the electricity current flows (P1→P2or K→L). If the arrow faces the reverse direction, the reading meter will display 0.
DanK
2025-08-18 16:47:29
This product is advertised for three-phase monitoring, but the three sensors can be used to monitor three independent circuits that are not phase synchronized. I plan to use two inputs for my 120/240 house mains, and the third to monitor my off-grid solar system. To verify it would work that way, I used the setup shown on the attached photo. I connected Phase 1 to a house outlet and Phase 3 to the output of an inverter. It worked fine and accurately measured the power and current on the two legs. I found the best way to initially set up the unit with the Tuya Smart app was to use your local Wifi. Once hooked into your Wifi network the unit gets back online within a few seconds when its power is turned off and on. The app takes a few seconds to react when the load changes, but that's not an issue for me. The unit powers itself form Phase 1 and won't work if you just have Phase 2 and/or Phase 3 connected. The included antenna is nice because the signal has to go through several walls in my house to get to my router. So far, I'm very happy with this monitor and would recommend it.
Andrew Martinez
2025-06-29 11:55:31
Excelent product.
Bluegrass
2024-12-11 19:11:34
Easy to install
Recommended Products
$327.33
$ 99 .00 $99.00