Your cart is empty.
Your cart is empty.
Mini Toggle Switch Can be used on low voltage or high voltage circuits ideal for switching lights or motors.
Each switch comes with two hex nuts, a flat and a locking washer. Easy installation. Fit 6mm hole is required and the switch will sit in nicely.
The switch is suitable for panel mounting and has a reliable action making it suitable for a wide range of applications.
Kindle Customer
2025-08-24 18:50:28
This was an exact replacement for a similar switch that failed in my DIY astronomy power box. Advancing age and meds made it impossible to solder wires to the switch when it was installed so I wired short pigtails to the contacts, installed it, then used Wago connectors to reconnect it to the box's wires.
Liem
2025-08-06 11:12:23
Switches work as expected
ER Andromeda
2025-05-18 18:07:56
These switches work just fine. I probably should have bought something bigger, as my 77 year old eyes needed some magnification to solder fine wires properly without bridging between poles. But a younger hobbyist should do OK
Robert McHugh
2025-04-26 10:36:56
I like these, they have solid engagement with position click and good feedback. I also like the rubber hats for the switches, they provide a sort of waterproof (not that a enclosed plastic needs it) face.The only think to be careful of is the solder connection, you must use a lower heat or they will melt the plastic holding them in and ruin the entire switch. A temp controlled solder station set on low works best.
Michael See
2025-04-25 13:47:55
This is a small switch that could turn on 3 different lights or 3 other lights with different voltages like the starboard light and an indicator light on the dash. I soldered wires since there are no spade lugs but, it works for low powered LED bulbs. I did use the rubber cover for the "dark" look on a power box (check YouTube) when I needed a double throw ( 2 separate switch lines) switch.
NDHElectronics
2025-04-06 21:47:36
Used these to build a two battery series or parallel battery pack. The switches are used to switch between a parallel configuration and a series configuration. They have had around 1.5 Amps @ 24V run through them and haven't failed or gotten warm from the haigher power run through them.
robare
2025-03-29 17:01:58
I tested all switches with an ohmeter for continuity, a few had no continuity, initially, until I mechanically cycled the switch lever, that fixed the continuity issue. I marked those, to use last!The rest all worked as they should.
Consumer man
2025-03-01 13:04:23
My job we use tons of switches, all micro, or mini or what ever you call them,, they solder just fine, get a decent iron or not, you tin the connection fast (within 2 seconds ) unless you going thru hole, then tin your wire, put through hole, hit with flux or put alittle solder on your iron tip to transfer heat, and there you go,, nothing melted, no problems,, all good..
ali kashefi
2025-02-05 11:23:39
This switch is not good for AC power for DC power yes is good
Jeremy
2025-01-08 15:23:30
Works as advertised. Compacts and easy to solder to, but don’t overheat the switch when soldering or the plastic switch body may get soft or melt.
Steve Snow
2024-12-26 12:36:31
Use to switch between rotary and Y axis on laser engraver. Works perfectly!
Recommended Products
