Your cart is empty.
Your cart is empty.Product Description
EANOSIC Solid Carbide Blue Nano nACo Coated Spiral Up Cut Router Bit with 1/4 inch shank and 1/4 inch cutting diameter
About The Blue Coating
- Blue nano coating Series Router Bits utilizes a special unique carbide with composite coating for a longer lifetime (up to 2.5X longer life compared to uncoated bits) in modern materials.
- Blue nano coating enables the tool's cutting edge to retain crucial sharpness and lubricity. This provides longevity and produces cutting results of the highest quality.
- Coating prevents high heat and oxidation which is detrimental to cutting tool performance.
Up-Cut Spiral Bit
Used for smoothly upcut mortise and tenons, grooving, slotting or routing deep blind holes. It performs faster cutting while pulling the chips up. Plunge cut leave with clean edge and bottom. Better than straight bits.
High Processing Efficiency
The edge of end mill bits is HARD and SHARP, process the heat treatment materials under 32° with high speed, reduce changing times and improve the production efficiency.
Industrial Quality
Industrial quality control to ensure best performance.
STRONG & DURABLE
The Blue Nano nACo Coating with High Hardness and Heat Resistance.
Chris G.
2025-08-28 18:27:08
stays sharp, accurate size., the coating on them helps…. great for fine work or just hogging out a big area
Patrick K. Jaromin
2025-07-26 21:11:55
I've been using Amana bits, but needed some compression bits so figured I'd give these a try. They work great so far - have used in 3/4" plywood at 3/8" DOC and in the neighborhood of 600-1000 in/min speeds on my big CNC. Have also used these on Mahogany and rock Maple on a smaller machine at slower speeds, 1/8" doc with success. Liked them so much I bought a second set so I can have one set with each machine. Highly recommended.
John
2025-06-20 17:35:23
I ran one of these at around 300ipm in walnut today and it held fine. No tearout either top or bottom with no chatter. I probably could’ve pushed it harder.If you’re gonna sand your edges anyway, these are superior to a down cut. I could’ve gotten a cleaner cut on the bottom surface but I set my machine to just expose the spoilboard and not cut deeper. To take advantage of these they have to have all flutes engaged.
Caleb
2025-06-03 17:21:28
Stays sharp longer. We'll worth the money. I do a lot of CNC projects and I'll be buying these bits from now on.
Randy G.
2025-04-27 19:28:43
Does the job it was meant to do
Fichy
2025-04-09 18:23:02
I do a lot of CNC machining and these are great!
John DiGilio
2025-03-07 14:05:56
Worked perfectly on our shop cnc router
Robert Haase
2024-12-28 20:41:43
This thing really pulls the chips out of the hole when making mortises. The only problem I had was that it pulled the bit down into the hole so hard, it pulled itself loose and slid further out, making my mortise too deep. Once I tightened it really tight, it worked well.
Recommended Products