Your cart is empty.
Your cart is empty.Product Description
Fitment
Compatible With Ford 6.7L Powerstroke Diesel 2017-2020
Michael Hernandez
2025-08-25 09:07:44
I have had 2 different manufacturers and designs before this one. The first one was a plastic tab and it kept blowing off. The second one was a design similar to this one but the crimp design was terrible and we kept loosing it when taking it off and on for a fuel filter change. This one is great!
Nicole misner
2025-05-25 14:43:34
Anybody who’s replaced their filter on a 6.7 has ran into the injector return line breaking at the filter. This is a perfect fit and replacement to repair the line instead of having to buy the whole line for $150.
Matthew J.
2025-05-23 09:48:38
Whatever you do if you buy this thing, do not use the piece of junk hose clamp that is included with it. Period. I am now currently stranded on the side of the road at 10:30pm, because the clamp doesn't hold enough pressure to keep the hose from blasting off the fitting. I'm hoping the the zip ties will hold me over until I get back to the house.*UPDATE*So a combination of gorilla glue, zip ties, and divine intervention I was able to get home. I immediately got a 3/8 inch hose clamp, the kind that tighten down with a screw driver, and put it in place.The aluminum peice is very well built and holds on great. It's well made and does what it needs to. The only issue is with the included hose clamp. Do yourself a favor and buy some 3/8 worm drive hose clamps if you order this part. It will save you a LOT of trouble.
Joey D.
2025-03-04 11:36:41
Worked great until it didn't. The included clamp is junk. Get a small worm drive clamp unless you want it to pop back off after the under hood temperature increases. The factory rubber hose is very snug trying to fit up on the nipple even with the included silicone lubricant. Even with the snug fit and clamp in perfect position, after the truck got up to operating temp for 20 minute, it blew the line off. Takes 5 minutes or so to install and you're back up and running. Beats paying nearly $200 for the entire factory return line assembly and you won't have to worry about it breaking again. You just need a better clamp. The only thing they could do to improve it is add a second retainer clip in case you drop the only one included and get rid of the spring clamp for a worm drive. The fitting itself is top notch.
WF250G
2025-01-01 11:46:07
Not the plastic kind, should not break.
Kerri L.
2024-12-08 11:18:36
Install was easy came with lube for the O-rings. we'll see how it holds up!
Russell K
2024-11-15 13:40:03
Good fit, would buy again.
Recommended Products