Your cart is empty.
Your cart is empty.Product Description
Please Note :
- During installation, the temperature switch should be completely close to the mounting surface of the tested appliance.
- Do not collapse or deform the plastic / metal shell during installation.
- For metal temperature controller, when using, do not remove the insulating sleeve to avoid electric leakage.Not suitable for working in water.
- Not suitable for air temperature sensing, only applies to contact sensing.
Reset Temperature
Normally Closed: When the temperature falls to the reset temperature, the thermostat contact can be connected again. (If the reset temperature is not reached, the thermostat contact is also disconnected)
Normally Open: When the temperature falls to the reset temperature, the thermostat contact can be disconnected again. (If the reset temperature is not reached, the thermostat contact is also connected)
Customer
2025-07-21 17:11:21
Only tried a couple of them but so far they work pretty well. These were the only 10a N.C. ones I could find and it was a good price for the assortment. Like most bimetal thermal switches, they aren't super accurate but it's perfect for an additional fail-safe in addition to a thermal fuse or another type of fail-safe. The specs show that they open (turn off) at the trigger temperature listed, then they close (turn back on) once it drops to the reset temp (from memory I think roughly 25-35°C under the listed trigger temp). Always check it works before installing. Perfect for heater fail-safes. This will not replace a temperature controller for active temperature maintenance/control, in case anyone was under that impression. I would buy again.
Canadian Traveler
2025-02-08 13:54:09
Tested a few different temps from this set up and they all behaved differently - going back
Recommended Products
$180.40
$ 74 .99 $74.99