Your cart is empty.
Your cart is empty.Product Description
For Home Appliances & Garage
From the water heater, the boiler system to the garage door, they will show the open and close status of the door or equipment. Add these indicators to any circuits.
DIY Project
e.g. PLC training project
Industrial Electic Control Panel
For any electric panel such as Switch Cabinet, Power Distribution System, HVAC Panel, Escalator Control Panel
Design Improvement
Refit to the automobile or boat engine room to assist in steering
Dan King
2025-08-17 19:54:07
I installed one inline with a light switch at church. Great notice button I use it to remind me that the Church cross light is on and should be turned off at the end of service. Only thing is they do not turn off instantly but slowly fade. Does not affect performance.
Lappost
2025-08-14 14:33:56
Me agrado mucho que lo que pedà fue lo que recibà le sigo dando un 5
Chris
2025-07-18 12:03:12
Perfect for the application I’m using them for and bright enough to get peoples attention
Tim B.
2025-05-14 11:51:25
I love these lights and I have bought many of them. I wish I could give more than 3 stars, but the terminal connectors are very loose in every one I have purchased, and honestly, it scares me. The last thing anyone wants is a wire coming lose and bridging another connection. Another issue that bothers me is the wire from the light to the terminal connection. It’s extremely thing and fragile. I will gladly still purchase these lights and give a 5 star review if those issues can be fixed
Steve
2025-03-12 10:50:13
They were a very cheap light for my initial setup and have been working good so far. I would recommend them if you were working in an area that is not going to be to rough. A rough and tough environment would most likely damage and destroy them. But if you don't think you would be banging into them they should work pretty good.
McGee’s Smokehouse
2025-02-28 18:37:33
I have electricity in my carport I installed these lights so I know the electricity is on when I walk outside
R P
2024-12-21 14:21:00
Installed one of these indicators in an industrial environment. Not in direct sunlight but can be bright during the day. You cannot tell if the LEDs are ON or OFF unless the room is dark! I tried both and they are the same - DIM when ON.These will not work in my application. Yes I have correct voltage and they are wired properly.
iceman
2024-12-11 17:00:58
These are great
Recommended Products