Shopping Cart

Your cart is empty.

Your cart is empty.

uxcell Electronic Vibration Sensor SW-520D Metal Ball Tilt Shaking Trigger Switch 10Pcs

Free shipping on orders over $29.99

$7.29

$ 2 .99 $2.99

In Stock
  • Model Number: SW-520D; Max.Voltage: 12V; Rated Thermal Current: 20mA
  • Insulation Resistance: 10M ohm; Conduction Time: 10MS; Max.Temperature Resisting: 100℃
  • 【CHARACTERISTICS】SW-520D is a ball type tilting vibration sensing unidirectional trigger switch. The appearance is sealed with heat-shrinkable tube to protect against dust and moisture.
  • 【ADVANTAGE】Made of metal, the electrical characteristics are similar to the switch, but it is not as dangerous as the switch and has environmental problems. It has a single-passing characteristic when shaking, and it is more convenient and safe to assemble.
  • 【APPLICATION】This switch is suitable for touching off the small current circuit not suitable for acting as the mains switching. Applied to the eletronic , small household appliance, sports equipmens and anti-theft devices.


Description:
1.SW-520D is a ball type tilting vibration sensing unidirectional trigger switch. The appearance is sealed with heat-shrinkable tube to protect against dust and moisture.
2.This switch is suitable for touching off the small current circuit not suitable for acting as the mains switching. Applied to the eletronic , small household appliance, sports equipmens and anti-theft devices.
3.Made of metal, the electrical characteristics are similar to the switch, but it is not as dangerous as the switch and has environmental problems. It has a single-passing characteristic when shaking, and it is more convenient and safe to assemble.

Working Characteristics:
When the product tilt to Conductive terminal more than 15℃, is open circuit OFF-state,when trigger end (gold-plated pin end ) below the horizontal gradient greater than 15℃ angle, is closed circuit ON-state.
In horizontal position, shaking easy to trigger, while the golden feet up, shaking is not easy to trigger.

Specification:
Product Name: Vibration Switch
Model Number: SW-520D
Conduction Time: 20MS
Max.Voltage: 12V
Rated Thermal Current: 20mA
Insulation Resistance: 10M ohm
Max.Temperature Resisting: 100℃
Pin Size: 10mm x 0.6mm(L*D)
Body Dimension: 13mm x 5.5mm(L*D)

Package Content:
10 x Vibration Switch


nmashe1
2025-06-29 10:58:42
This year when I went to turn on my electric heater, it would just run for a second,turn off, beep, and then have a single dot flashing in the display. Research showed that this was most likely a defective tilt switch. I verified there was no continuity between the legs of both switches when the heater was in the upright position. Both switches had gone defective while unit was not in use over the summer.Although these replacement switches are not identical, they worked perfectly. I'm no soldering expert, so I clipped the legs of the old switches off at the base, leaving them attached to the board. I then soldered the new legs onto the old ones without a problem. Took maybe one minute a piece. Unit back up and working perfectly! $8 vs $80 for a new heater. Good buy.
Rafael
2025-05-12 14:14:36
Muy útil
Customer
2024-11-21 09:29:54
A switch, by definition, should achieve an open circuit somehow. At no position did these ever reach open, only varying levels of resistance. And someone, PLEASE, do a better job of translating product descriptions into English!