Your cart is empty.
Your cart is empty. Vici VC480C+ LCD Digital Milli-ohm Meter Resistance Tester 4 Wire Micro Ohm Meter
Features:
1. Large LCD display for easy reading.
2. 4 wire testing, capable of testing extreme low resistance.
3. Accurate measurement of conductor, electric heating elements and solder point; It is used widely in building lightning protection network, equalizing ring of glass curtain walls, and communication antenna.
4. High measurement range of 0.01mΩ to 2kΩ at 6 ranges.
5. HOLD key for data hold.
6. Backlit LCD for easy reading under dark light.
7. Strong anti-magnetic and anti-jamming functions.
8. Full function protection.
Specifications:
Range: 20mΩ/200mΩ/2Ω/20Ω/200Ω/2kΩ ±(0.5%+3),20mΩ ±(1.5%+3).
Low battery indication:Approx.less than 7.5V.
Data Hold:Yes
Function protection:Yes
Sampling rate: 3 times/sec.
Operation mode: Manual range
Max.display: 1999
Power source: 6x1.5V AA battery or external DC 9V power source(not included)
LCD size: 75×52mm
Weight: 580g
Package List:
1 x VC480C+ Digital Milli-ohm Meter
1 x test lead
1 x English Manual
Mr Guy with too many hobbies
2025-08-27 11:00:34
Had multiple outlets in a house one one circuit so I simply wired a plug with three open wires sticking out and went from outlet to outlet and writing the resistance down on paper for each one. As I got closer to the short the readings became less. Was able to trace the short to an outside outlet box.
kay bhee
2025-07-06 17:20:10
better options cost over usd 1000 from japan, etc...you must RE CALIBRATE VERY OFTENto double check your results....you have to be super gentle....but you can measure down to about 10 MICRO ohms...useful in some cases....
S. A. ROBBINS
2025-04-22 19:01:24
The fundamental problem is that the test clips are not very good and have no teeth to speak of. That means you don't get a good connection to anything you are trying to test. Would have been really nice if those clips came off and had test probes.The other big problem is that the zeroing is very tedious and time consuming. This meter really needs autozero which shouldn't have been that hard to do. If the test clips were better it would help.Also there is continuous drifting of the zero point. If you just leave the clips connected together, the zero point will drift.Overall a very disappointing low ohms meter.
ed
2024-12-22 18:09:16
Useful for testing short circuits on PCBs and checking resistance of cables and connections.
Recommended Products
$573.00
$ 99 .00 $99.00
$2,778.75
$ 99 .00 $99.00
$46.99
$ 23 .99 $23.99