Your cart is empty.
Your cart is empty.Complete your exhaust repair with a Walker MEGA preformed band clamp. Designed to ensure a tight connection and inhibit leaks, Walker hardware is manufactured from durable and robust material for long service life.
Michael
2025-08-26 18:52:30
Clamp works just like factory but doesn’t have the factory tab so you can actually remove it. I’ve bought 2 so far and the quality is great
Florp
2025-08-12 17:35:41
If you live in a place where they spread that green de-icing crap all over the roads in the winter, you might have replaced this part once already.The clamp itself does not corrode as it is made of quality stainless, but unfortunately the bolt, and the barrel shaped "nuts" are made of "fuse-together-after-about-5-yearsium". All the junk on the New England roads in the winter time I'm sure is the culprit. The loss of material due to corrosion caused the clamp to loosen ever so slightly and the exhaust to rattle due to the vibration. The bolt becomes completely non-removable as it literally becomes one with both ends, fused together for all eternity.The solution is to carefully dremel off the old clamp on each side, pop on a new one and be good for another 5 years or so. I have replaced this on my Tahoe twice. Was happy to see the part still available here after so many years.
Jef K
2025-07-31 11:06:16
2018 Silverado 1500. Perfect fit. Top notch made in America part. Not chinese scrap.
Ryan
2025-07-19 18:56:29
After reinstalling the factory exhaust on my 2016 Tahoe I had a horrible rattling because the factory clamp stretched when I clamped ot down. This took care of my problem perfectly.
Chris E.
2025-06-28 13:47:44
My exhaust clamp on my truck was too rusted to get off so I had to cut it and this is the perfect replacement it was exactly what I needed
Speedmod101
2025-06-22 11:41:29
Fits like it should.
Joe
2025-05-29 16:18:34
The Walker 36522 Exhaust Clamp for Chevrolet Silverado 1500 is a bolt in replacement for my 2016 from the factory cat to the flex minus the tab. Works as it should.
Dan
2025-05-24 10:03:01
I had this silly, stupid clamp rust out and loosen up on my 2016 Suburban (yes my $45,000 Suburban blew an exhaust leak so I'm super stoked about that - but I digress). I wanted to replace it with OEM quality because I plan to have this truck for awhile, so I bought an OEM General Motors genuine part. Unfortunately shipping was delayed and I was desperate to get my truck back together. I cross referenced the part to this Walker part and since it was available as a Prime item for almost half the price, I gave it a shot.Funnily enough, both parts arrived on the same day. Upon close inspection I found that this Walker clamp is THE EXACT SAME THING as the genuine GM piece. Same manufacturer, same part number, same build quality, same materials. They were literally stamped with the same numbers and information.The only difference was that the GM part had the retainer tab on the top which you really don't need, and in fact NOT using it makes re-installation easier. I used the Walker part and it installed beautifully and did the job. I'm returning the GM part and getting my $30 back. Go for this one, it's the best solution to a stupid, STUPID engineering choice (and failure) by GM.
Michel
2025-04-28 17:27:40
Très facile à installer
Customer
2025-02-13 17:49:58
Exactly what I needed to install the cat back exhaust on my 2010 sierra
blair cutler
2024-12-26 12:00:12
Fit as well as the original cllamp but this one is stainless steel so should last longer. Price was cheaper than OEM as well.
greg
2024-12-16 18:05:01
Worked very well
jane
2024-11-25 17:43:21
It works
Recommended Products
$19.99
$ 8 .99 $8.99