Your cart is empty.
Your cart is empty.JimC
2025-08-31 13:16:04
The sink itself is pretty much as described in the listing. Some things I'd liked to have known that weren't in the description:1) The trap shown in the picture is not supplied. You do get the drain/tailpiece (1-1/4"), braided supply lines, and the faucet.2) This sink does not have an overflow opening. Something in the description implied that it does.3) The mounting is by studs (supplied) through holes in the porcelain. The holes are an inch above the bottom edge of the back of the sink. I haven't mounted the sink yet but it seems that any pressure on the front edge of the sink would cause the back edge to pull away from the wall, and a lot of pressure would break the sink off the wall.4) The sink drain is far off-center. The sink is 17.5" wide at the top and 17.25" wide at the bottom. The drain is 6.5" from the faucet side. This may present a problem depending on where the drain inlet is on your wall.5) The mounting holes are far apart and not centered. The mounting holes are 13" apart , 1.75" from the faucet edge and 2.75" from the other edge. The holes are slots about an inch wide and a half-inch high. They aren't the kind of slots that let you slide the sink down over the studs so it will likely take two people to install the sink.I haven't installed the sink yet. If I learn any more when I do, I will update this review.Overall I like the sink. It's cheap, modern without being far-out (I have a Victorian house), and small (I have limited room for the sink if I want the bathroom door to open all the way).
Max A.
2025-08-08 18:21:04
Both the porcelain and faucet have a great finish and feel sturdy.
kauai_buckeye
2025-08-03 16:55:38
The sink and faucet are high quality and look great. However, the angle of the faucet causes the water to hit the front wall of the sink. With the faucet fully open and with normal water pressure, the water actually hits the top of the front of the sink and floods the area. I fixed the problem by installing a 1.5 gpm aerator from Home Depot. Also, the box didn't include the installation hardware (lag bolts, washers, etc.) so I had to purchase them separately. As others have said, the installation was more difficult because the mounting holes are only 3 inches from the from the center back corner of the sink.
Grant Rabideau
2025-08-02 16:50:45
Matched description
carrilloz
2025-07-22 10:15:17
Wonderful unit, compact and durable. Item was properly packaged and was installed without any issues. Will definitely consider buying from this seller.
Kevin Lanham
2025-07-11 10:28:12
The porcelain bowl is the only part of this is useable… If you go find your own mounting hardware as the cheap junk they included will strip out or break completely (ask me how I know).The sink is mounted by a double threaded lag bolt. If one side screws into the wall leaving a fine threaded bolt on the other side to mount the sink. The first stripped out about halfway into the predrilled cedar forcing me to use vice grips to screw in the last half. The second did the same, but broke in half about 3/4 of the way in. I had to use a grinder with a cutting wheel to cut them back out to install a different sink.The drain might work, but it’s thin plastic junk that doesn’t match standard 1 1/4 US pvc. I’m assuming it’s designed for Chinese sizes?The faucet… Again, all plastic. The huge problem is that the lines are supposed to be preinstalled (per the instructions). Mine were not. Due to the design, it’s impossible to install them yourself and tighten them enough to prevent leaks. I own every plumbing tool imaginable and have nothing that can reach inside a 6†tube to tighten the nuts with less than 1/8†clearance surrounding them.The sink itself seemed decent quality. Too bad they couldn’t have paired some decent hardware with it…
Customer
2025-06-28 11:05:22
The faucet is too big. The spout design causes the water to flow out of sink.
Nicole d. Harris
2025-05-08 18:32:29
Beautiful sink! Perfect for what we needed it. Looks great and a much better price than ones that didn't come with the faucet and drain fittings. Very happy
Tina
2025-04-24 13:17:39
This sink is the perfect size for a tiny powder room we installed where a coat closet was. Even the faucet is a good quality faucet and looks great. Love this little sink!
Dominique Skelton
2025-04-12 14:15:53
Exactly as expected
LenaS
2025-01-21 14:40:42
The sink is very small which is what I wanted. However the tap provided has an angle on the spray so if you turn it onto max flow, it sprays out the front of the sink. Boo!Also if you are mounting into wood framed walls, fingers crossed that you have studs in the exact correct spots. There is no room for error, which is a huge design flaw. We put wood under it.
Ironoresteel
2025-01-18 14:50:55
Unsure how you would install sink in corner with the Hardware that was provided. Had to improvise.
Tariq javaid
2025-01-05 11:12:52
Yes like but should be little more bigger
Recommended Products