Your cart is empty.
Your cart is empty.Great Product
David Dumais II
2025-09-03 12:24:10
on my T/C Compass .30-06 with Burris Fullfield 4.5-14x42mm.......works awesome, thick, flush fit, 1 inchers6 screws to go through on each ring is my only complaint, but honestly it makes a stiff hold.
Tacky
2025-08-14 16:55:49
These are some of the best, most robust rings I have ever used, and have become the only ones I use on my rifles. Rock solid, able to withstand great abuse, and hold zero, from .22 to 50 bmg these rings won't let you down.
Shawn Davis
2025-07-17 10:03:49
A little loose on the rail but I knew this going into it as they are for a weaver base.Delivery driver made a u turn through my front yard running over my paver stone walkway in the process...
docduracoat
2025-06-30 13:56:03
These six hole rings are lightweight with the skeletonized upper half.I have them on an M-14 with a 3 -9 x 50 mm scope.They are the minimum height to keep the 50 mm scope bell above the rail.They are holding up to the .308 recoilThey are an excellent product for a good price
Robert Lemons
2025-06-14 17:36:32
I measured these scope rings with a digital caliper to determine the distance between the center of the scope and the top of the rail and it is 1.015". Weaver does not provide this measurement for their extra high scope rings. That's what the measurement is.These rings will likely be too low for putting a 1" scope tube on an AR-15 rifle. You likely be better off choosing scope rings that measure 1.20" or higher between the center of the scope tube and top of the rail.
Kindle Customer
2025-05-19 13:46:19
Very high quality product. Holds the Nikon P-223 on my Sig M400 very tight and sturdy. From other reviews, I ordered the extra height and my 32mm lens has barely any extra room after the lens cap is on. Based on this, it fits perfect but being "extra high" is a little misleading.
Josh L. Gabbard
2025-04-30 13:57:33
Ok, so I've seen all kinds of reviews for these rings pertaining to AR's. That's all well and good, but I put these on a Ruger American 308 with a Nikon Buckmaster 3X9X40 scope and they work flawlessly. They do just what they're supposed to do, and I don't think you'd be able to find a better set of rings for the money.
RJC
2025-03-03 19:46:17
I ended up returning these today. I bought them because they claimed to be "extra high" but they were shorter than these which weren't tall enough in the first place for what I needed them for. I ended up buying since they told me what the scope center to bottom is. The construction seemed nice on the Weavers though. Would buy them again if Weaver decides defines what "extra high", "high", "medium", etc. means. Will fit a XXmm lens description is useless when heavy barrels, rails, hand guards, etc can change that distance.
Chris K.
2025-02-17 13:12:39
These rings are quite a bit wider than your Weaver Grand Slam's or similar standard rings. With the pre-installed bases on my Mossberg Patriot and Savage 11, the front ring has no choice but to hang off the back of the base due to the cutout for the screw. The back ring sits perfectly flush. The issue is more aesthetic than anything since it doesn't interfere with ejection in this particular setup. I would still like to see an offset screw on a designated ring since it can be mounted in either direction. At the end of the day, they're nice looking rings that get the job done for a reasonable price.
Blkmrkt
2025-02-09 11:03:32
Fit and finish is great. The package says Extra High but they sit about the same as my low vortex hunting rings. They make the optic sit too close to the charging handle. Would probably be great on a bolt gun.
Kelby Tannas
2025-02-06 16:31:26
Arrived missing all hardware, no screws, cross bar, nuts or side clamp. Just upper ring and base but no hardware to assemble or attatch to rifle. Pretty useless without any hardware!
Pancho
2025-01-24 17:49:34
Pretty good.
lance rieberger
2025-01-05 13:26:26
Excellent product and service
Recommended Products
$45.92
$ 20 .99 $20.99
$22.39
$ 10 .99 $10.99