Your cart is empty.
Your cart is empty.Our company sells all kinds of electronic components with excellent after-sales service and professional technical consultants. Please contact us by email if you have any questions.
Timothy A Stiel
2025-08-12 11:37:37
Holds the Y Axis motor well.
rkruz
2025-07-27 11:38:04
The Weideer 42mm Stepper Motor Mounting Bracket is very strong and stiff made from 1/8" thick steel.It has corner reinforcements, spot welded in 3 places to make it extremely stiff.The paint is very well done.Convenient that its provided with all the hardware needed to mount a NEMA 17-size stepper motor.My NEMA 17 stepper fit perfectly.The slotted base holes are long enough to reach past the end of the motor to allow enough clearance so that mounting bolts can be installed after the motor is screwed in place.The mass of the bracket will also help with heat dissipation from the motor.
Mike Someone
2025-06-29 15:00:59
These are great solid mounts. 4 stars because the clearance hole should be about 2mm larger to fit gear head motors, but I was able to machine them to fit my motor.
DM
2025-05-06 16:43:11
If you don't need to align the stepper motor to pulley, than its all good. Unfortunately I need to align stepper motor and the pulley. Holy crap, had to install & remove few times to get the alignment. In order to align it, I had to physically remove stepper motor due to screws being hidden behind the stepper motor.besides that, it works with minimum flex.
N. Andrews
2025-03-31 15:23:18
Perfect for my situation
Billy Crawford
2025-01-31 17:57:55
Went great with my taco salad
Tristen D.
2025-01-09 10:50:28
Mounting slots too wide to fit ender rails. Fits perfectly on the motor though.
Ed Cunningham
2025-01-04 14:12:26
as described
Recommended Products
