Your cart is empty.
Your cart is empty.
This Wesco 272303 vertical slide deheader is 5-7/8" in height, 17-3/4" in length, and is designed to open steel drums without the use of a cutting torch. It has a hardened steel blade for efficient cutting and a plastic handle for a secure grip. This vertical slide deheader has a replaceable blade (Wesco 272304).
Wesco manufactures material handling equipment. The company, founded in 1948, is headquartered in North Wales, PA.
S R
2025-08-09 12:01:29
This tool is simple to use and makes a nice cut to remove the top. It is in the mid range cost range, but is better then some higher priced units.
Mr. Skipper
2025-07-18 13:36:24
Works exactly as it should. Well built, and easy to use.
Customer
2025-06-25 10:16:47
very hard to use compared to other ones I have purchased in the past
P Soup
2025-04-30 15:51:17
My first time using this, it took about one minute or so to get a barrel lid cut off. It was basically easy to use, just a matter of technique, and I think soon I will be faster. It appears to be pretty heavy duty, and did not struggle to get the drum lids cut off. I would recommend this for most people, if you rip drums open all day, maybe get an automatic super expensive one, but this is a decent product.
Customer
2025-04-29 16:22:32
We have this and several others that are essentially the same design but with a curved blade. While they both do the same job, this one is harder and more laborious to use, goes forward instead of back (which is more natural to all of us), and leaves a much more jagged and sharp edge. Enough so that we decided it was best to trash this one.
Alvin Wilks Jr
2025-04-05 16:38:13
It did exactly what I needed it to do...in very short order!!!I would not hesitate recommending this product to others.
CONCHEM
2025-02-21 13:52:37
We have a ton and a half of 55 gallon barrels at our place and lots of people are looking for clean burn barrels. It takes less than and minuet and a half to take the top of clean.
Travis Galligher
2025-01-11 17:49:03
The handle grip rubber is a bit thin. The leverage handle could be a bit longer for ease of use. I slipped a piece of pipe over it to help. Cuts well once you get some practice in
Brent
2025-01-01 11:15:58
Never used one before, bought this one strictly by the reviews. It works fine, even on slightly dented barrels. I wouldn't want to use it for 8 hours a day, but it is easy to use.
Recommended Products
$134.66
$ 62 .99 $62.99
$37.38
$ 16 .99 $16.99
$92.74
$ 45 .99 $45.99
$1,199.99
$ 99 .00 $99.00