Your cart is empty.
Your cart is empty.Woodhead 35970 Pulling Grip with flexible eye can be used for a wide range of applications ensuring bumpless pulls and long-life operations. Made of high-quality galvanized steel wire, the flexible pulling grip is resistant to rust and corrosion. The economical pulling grip can be used in different industrial environments like for plant wiring, and rewiring, and underground electrical pulls. The even and thin design of this safety grip is ideal for both generous and tight spaces. Featuring a flexible eye, the mesh cable ensures an easy attachment to the pulling line.
steve
2025-07-27 20:36:25
Pulled 500 kcmill no problem! Saved lots of time
Paul Raulerson
2025-07-11 18:00:19
Good for long runs
Terry
2025-05-27 12:46:12
I not only pull cable with this I also pulled 1†pvc pipe. It works great. Its a little trouble to put on 1†pipe but when you get it on it holds great and is easy to get off if the pipe
raheller
2025-05-18 10:02:04
Essential assist for pulling multiple power cables, downsides no USB ports or cupholders
Customer
2025-02-20 12:52:51
So very simple to use, works like a Chinese finger trap didn't have to trim the wires at all hooked up to the 1400 lb flat strap pulled through the conduit smoothly with no binding. I did use the "soap" for pulling wires.Came off as easy as it went on. Highly recommend for any cable pulls
Karl
2025-01-04 17:36:26
Only praise. The puller did the job and didn't complain. Pulled 4, 1/0 cables 250' through 1.5" conduit. Had a tough 90 deg. bend to navigate, and it held up. On to live another day. Good value, when the job just can't go wrong & you require results.
Jason
2024-12-12 10:04:16
Found this tool by accident. Was not sure if it was sized correctly. I guessed my 3 3/0 and 1 4awg measured at 1 1/4 inch. That is the upper lot of this grip. It fit great even after I taped them all together for the pull. I added some tape over the grip by the end as the instructions online suggested. Little lube and no problem running this bundle thru 270degrees of bends and 50 feet of PVC conduit. I tried mule tape to the loop to pull with. The grip was used once so far and I find it so valuable I bought every size smaller that I could find. No more stripping wires back to use the copper to make the pull loop. Yes would buy again.
Dan
2024-11-30 11:39:02
Pulled SER cable using my backhoe and ALOT of force and it survived
Customer
2024-11-25 12:51:01
Worked perfectly, save me hours of work
Recommended Products
