Your cart is empty.
Your cart is empty. WWZMDiB 4Pcs HX711 Load Cell Amplifier 24-Bit ADC Weighing Sensor Module used to measure force, pressure, displacement, strain, torque, acceleration.
💎【HX711 Weighing Sensor Module】: used to measure force, pressure, displacement, strain, torque, acceleration.
⚡【Voltage】：2.6 ~ 5.5V
🥇This module uses 24 high precision A/D converter chip hx711.
🥈The HX711 uses a two wire interface (Clock and Data) for communication. Any microcontroller's GPIO pins should work and numerous libraries have been written making it easy to read data from the HX711.
🥉Support Widely used in aerospace, mechanical, electrical, chemical, construction, medicine and many other fields
【Features】:
-Two selectable differential input channels
-On-chip active low noise PGA with selectable gain of 32, 64 and 128
-On-chip power supply regulator for load-cell and ADC analog power supply
-On-chip oscillator requiring no external component with optional external crystal
-On-chip power-on-reset
-Simple digital control and serial interface: pin-driven controls, no programming needed
-Measurement Resolution: 24 bit
-Selectable 10SPS or 80SPS output data rate
-Simultaneous 50 and 60Hz supply rejection
【Specification】：
-Differential input voltage : ±40mV ( Full-scale differential input voltage is ± 40mV )
-Data accuracy : 24 bit ( A/D converter chip )
-Refresh frequency: 80 Hz
-Operating Voltage : 5V DC (2.6V ~ 5.5V)
-Operating current : -Operation supply voltage range: 2.7V ~ 5.5V
-Operation temperature range: -40 ~ +85℃
-Size : 33mm x 20mm
【Package Includes】:
4Pcs HX711 Weighing Sensor Module
4Pcs 10pin (6+4) Male to Male Header pins in 0.1 inch pitch
10Pin 21cm/8 in Male to Female Jumper Wires.
10Pin 21cm/8 in Female to Female Jumper Wires.
tinker
2025-09-03 17:38:31
I'm reading a 5 ton load cell. Looking to record a force curve for a 100 ms impact, so I needed the promised 80 hz sample rate. (Wanted more, but this is "good enough")The undocumented change required removing a soldered 0 ohm resistor (a short) from one location to another on the breakout board.... Tiny ... Have a sharp soldering iron and some skill.5 stars for value. Even with the challenge.The
Steve B.
2025-05-10 16:42:18
Used two Load Cells to demonstrate the effect of torque multiplication for a 5th semester mechatronic intern project. She designed, build, and programmed this, including making the gears on Creality 3D Printer.
Matthew C.
2025-01-04 15:55:58
using these to convert other loadcell devices, to this chip, to use for nodemcu projects.
Recommended Products
