Your cart is empty.
Your cart is empty.NC spotting drill. 90 Degree point angle. Made of 8 percent cobalt and high speed steel. For more precise centering work on NC/CNC machine. A larger diameter in respect to the subsequent drilling tool permit to obtain the centering and chamfering simultaneously.
Henry
2025-09-03 14:58:05
The media could not be loaded.
Ian Mazursky
2025-09-01 13:06:21
This is a good spotting drill however the shank is way too long.Especially on my mini lathe, its unusable. However the grind is good and it does work.They just need to make them a little smaller.
nick
2025-07-06 10:41:01
Really nice, I used this for a project that had 150 holes, also used it to machine chamfers!
Steve
2025-07-03 18:08:21
Maybe good for very light work, but it won’t last long without sharpening.
Karin Flowers
2025-06-16 15:25:39
Very sharp. No coating, so it's safe to use on aluminum.Unlike many other cutters I've bought on online, this one was properly packaged, and covered in an oily substance to protect against rust during mailing.
JimP
2025-05-28 17:58:09
Cuts into tool steel without an issue.Spot and chamfer at the same time, I don't pick up a countersink anymore. I even use it by hand to deburr the back of a hole.Best of all, it is super easy to sharpen. Whereas a single flute countersink requires fixturing to sharpen properly.
Customer
2025-05-10 15:41:37
Great price, fast shipping
Vincent Mazza
2025-02-21 10:06:24
If you’re expecting a .5, 90 degree spotting drill… Don’t. You’re going to get an M6 tap.
Jeff W.
2025-01-21 13:43:04
Runs true and cuts nice.
Recommended Products
