Your cart is empty.
Your cart is empty.NC spotting drill. 120 Degree point angle. Made of 8 percent cobalt and high speed steel. For more precise centering work on NC/CNC machine. A larger diameter in respect to the subsequent drilling tool permit to obtain the centering and chamfering simultaneously.
Annie
2025-09-04 14:56:40
High quality, very nicely finished. It's not necessary to have a ton of different sizes since they're only for locating where you want to drill. Much better for spotting than center drills because the 120° angle makes a 118° drill go right to the center of the spot without chattering. This spotting drill is very sharp and cuts with ease.
Customer
2025-08-07 10:21:55
Arrived as expected. Worked as expected.
Luis C.
2025-07-15 12:04:18
Excelentes herramientas par Fadal Vmc4020
B J Cass
2025-06-03 16:25:30
EXECELLENT
David F.
2025-04-17 20:08:17
Use for CNC spotting(center drill)
Cleavert Guyton
2025-04-03 12:38:49
Drill bit works well.
J Ris
2025-01-24 15:24:56
I bought this to mark and start the holes when I drilled and tapped the receiver of my Franchi Affinity 20 gauge. This bit is very sturdy and was extremely helpful to getting the holes started and aligned properly.
Customer
2024-12-31 12:23:28
These have a nicely ground finish and well packaged, each in a plastic box. I haven't checked them for runout but as a hobbyist they should be fine.
Recommended Products
