I'm using these for a handwired build of an Ergodox variant. I soldered wires straight to the tabs. The tabs have a split down the center because the clip is two pieces in the actual socket. I pushed a thin wire (or the diode lead) between this split and bent the wire flat on the tab, the soldered. The plastic housing of the clip did not melt while soldering, except for the one time I was distracted and left the iron on the price way too long. Even then the clip was usable. I soldered I'll a switch tester set with Gatreon, Cherry, Kailh, and a Razor switch all worked perfect in the setup. After soldering fit was still perfect. Shipping is from China, but came pretty fast since the shipper was prompt. They come in plastic strips of 10 that hold the sockets individually. They were easy to get out.

These sockets came a lot quicker than expected and are all in great condition. Straight off the assembly line and still in their ribbons. Awesome!

It's fit perfectly 🙂

Before to buy the product verify it is the correct hot-swap, this particular product work for cherry-MX switches.

Broke 2 hotswap sockets on my Keychron Q1 which were from Gateron.These work as a perfect replacement.

Socket per rendere hot swap una tastiera. La qualità non è il massimo ma fanno il loro dovere

Amazonなので、自キーer御用達の中華サイトより早くてその点は良い。50中3個、実装に問題なく、Switch側にも問題無かったが、接触不良or反応しないものがあった

Arrived just as described and fits perfectly to Gateron and Kailh switches.

取り付け方に注意してくださいね。反対に付けると後が大変になります。