Your cart is empty.
Your cart is empty.Create raised panels in a beautiful ogee and bead design with the Yonico 12148 vertical panel raiser Router bit. Two flute carbide cutters & 1/2 shank. Manufactured from C3 micro grain carbide, Yonico raised panel router bits create smooth, detailed cuts resulting in professional door panels. Highlights: - Create center panels for rail and stile cabinet doors - Premium C3 micro-grain tungsten carbide blades for a sharper & longer lasting edge - For use on table mount router - Silver induction brazing for maximum strength and durability - Smaller diameter allow higher RPMs and usage in lower powered routers - Manufactured with anti-kickback design to help prevent workshop mishaps Item Includes: 1 Router Bit There's no need to buy a heavy-duty router to make your own doors. Because of their smaller diameter, vertical panel raising bits require less horsepower and can be run at higher speeds than their horizontal counterparts. A vertical bit takes a much smaller bite out of the stock so your router won't get bogged down in the middle of a cut. We offer vertical panel raising bits with 1/2 & 1/4 shanks. Choose the larger shank diameter if your router collet will accept it.
Don Miles
2025-02-10 21:19:46
Worked fine with the hardwoods I was making picture frames with (Black Walnut, and Hickory). Take your time, and don't try to take off too much in one pass.
Recommended Products
$41.95
$ 21 .99 $21.99