Your cart is empty.
Your cart is empty.At Yukon Gear & Axle we make it our Mission to build quality parts that exceed expectation. It’s that simple! Our in-house engineering group utilizes state-of-the-art software to design product that’s then manufactured in partnership by some of the world’s foremost leaders in OEM manufacturing. After rigorous testing and intense quality inspection, we’re proud to call it Yukon.
Deacon Blues
2025-08-09 15:09:40
For months I had been dealing with the "ABS" and "Brake" warning light on my instrument panel... At first I thought "Oh, no big problem, just add some brake fluid...." the brake fluid was not low, then I thought the wheel speed sensor... I bought a new rear end speed sensor, replaced it... and I did not fix the problem, the "ABS" and "Brake" warning lights stayed on and my speedometer was not behaving correctly either... Then FINALLY, I understood that I needed a new "TONE RING" because the speed sensor was fine, did not need to be replaced, but the tone ring was bad. To replace the rear differential tone ring in a Dodge 9.25 rear end, you will NEED a "Differential Bearing Preload Wrench" (also available here at Amazon) to properly adjust the bearings on the left and right sides of the differential - this is critical and MUST be done properly and no other tool can substitute for it.
Cooper Zirbel
2025-08-04 14:58:03
Rebuilt my axle with Eaton TruTrac and this gear fit perfectly on it!
V. Hazera
2025-07-23 17:10:41
The perfect fit for my 2004 Dodge Ram 1500 5.7L Hemi. Very easy to install and you won't need to apply any heat to it or to the carrier but you'll need C-clamps, a brass mallet to tap it in and pliers.
Michael Priest
2025-07-05 12:20:01
A++ Heat it up in the oven for 20 mins @ 350F and it drops on!
Gonzo
2025-06-02 11:19:54
Yukon stuff seems as good as factory !
Lee
2025-06-01 11:40:08
Work as advertised.
William smith
2025-03-29 15:13:50
Perfect match
Christopher M.
2025-02-06 13:11:35
Was original Molar part. Good quality
Recommended Products