Shopping Cart

Your cart is empty.

Your cart is empty.

Yukon Gear & Axle (YSPBF-037) Inner Axle Dust Shield for Dana 30 Differential

Free shipping on orders over $29.99

$10.79

$ 4 .99 $4.99

In Stock
  • 1 Year Warranty
  • High Quality Small Parts
  • Engineered to Fit Specific Differential Applications
  • Fit type: Vehicle Specific


Yukon Gear & Axle manufactures a full line of top quality small parts to complete any job including ring gear bolts, crush sleeves, pinion nuts and washers, axle studs, thrust washers and much, much more. For all your differential small parts needs, look no further than Yukon.


A. Brose
2025-09-03 11:50:37
My old dust protector fell apart when I changed the front hub on my xj. This was a perfect fit. I have had good luck with Yukon products.
Slapda’dappy
2025-08-28 17:20:33
Got these when I was rebutiling my axles on my XJ. Cleaned up the axle and look great - the small things make a difference!
Gunmetalbluejeeptjs
2025-08-24 12:56:26
Put on my axle shafts for my 98TJ but the new shafts were thicker than factory so the the dust shields needed to be ground down in the center which I did with a dremel then slipped on
Liz Schmitt
2025-08-06 11:14:56
Ordered two while refreshing my Dana30. broke both trying to force over bump near end axle that keeps them located. Maybe try some PVC pipe the diameter of your axle shaft to tap them on. OEM is pliable and goes on by hand.
Mike+Claire
2025-07-21 09:07:28
100% need a heat gun to get these on. Brittle hard plastic when room temp. I could not install on a Yukon chromoly Dana 30 axle without first widening the opening with a drill and then heating with a heat gun.
Ken
2025-07-20 18:51:30
Perfect. The original ones had cracked. Ordered this, arrived as scheduled. This solved the issue and was a good buy.
Cameron
2025-04-24 13:25:05
Not much to say. They fit snugly on the axle. I put them on a Chyrsler 8.25 axle.
Richard W Marsh
2025-04-15 12:29:50
Looked everywhere including dealers and no one had it in stock I installed this on my wrangler yj with disconnect axle assembly and works perfect to keep out the road debris.
Gus K
2025-03-25 11:02:19
Fits better than the factory (2) piece guard. Slides over axle easily, and stays in position with a slight amount of tension. Typically the factory (2) piece guard releases at one end, and becomes less effective. If this, slightly softer material lasts, it seems like the better option.
Jimmy
2025-03-01 12:08:12
Check the size before you purchase
Customer
2025-02-04 16:12:06
Identique à l'original
Recommended Products

$205.99

$ 93 .99 $93.99

5.0
Select Option

$8.79

$ 3 .99 $3.99

4.7
Select Option

$55.99

$ 29 .99 $29.99

4.5
Select Option

$23.67

$ 11 .99 $11.99

5.0
Select Option

$23.32

$ 10 .99 $10.99

4.3
Select Option

$289.00

$ 99 .00 $99.00

4.8
Select Option

$31.49

$ 16 .99 $16.99

4.4
Select Option