Your cart is empty.
Your cart is empty. Description:
Row pin jumper cap, spacing 2.54mm, for shorting the adjacent two pin, generally used in single-chip and electronic circuits. Directly into the row of pins on it.
Dimensions: 6x5x2.4mm
Internal spacing: 2.54mm
Jennifer Rice
2025-09-03 14:06:31
Much tighter than original junk jumpers - need to be seated firmly. That is good.
Rugged Rick
2025-07-27 14:15:38
These jumpers work well. I used them on my Jetson Nano. Not sure what else to say. Nothing, but jumpers! :)
Josh
2025-07-20 13:06:15
A bunch of jumpers for a good price. They do what they are supposed to do. Can’t ask for more than that.
robert phillips
2025-06-15 13:30:47
Work as expected
Whitey
2025-04-25 14:58:23
Came with a random wall plate and another bag full of smaller sized jumpers. Only about 20 of the ones I ordered but with the free “gifts†and only needing one I’m content.
Neal A Cooper
2025-03-31 13:21:51
These are fairly basic little components, but essential when you need one. The jumper installs with some resistance, as it should. Recommended.
Ray C. Freeman III
2025-02-16 11:48:27
I mean, what are they going to screw up, right? Plastic part, check. Metal part, check. Did I count them? No, but 30 is believable. 2.54mm? I didn't measure, but they fit, so there.
Lisa
2024-12-13 20:57:56
They do not fit 2.54 mm pins well. The tolerances are terrible, and cause the jumpers to be forced on and end up misshapen.
Recommended Products
