Your cart is empty.
Your cart is empty.
Specification:
- Quantity: 100pcs (5 colors x 20pcs)
- Size:1.6 x 0.8 (mm) / 0.06 x 0.03 (inch)
- Emitting Color: White Red Green Blue Yellow
- Luminous Intensity: See the Specification Picture
- Viewing Angle: 120 Degree
- Forward Voltage / Current: W/B/G:3V-3.2V R/Y:2V-2.2V | 20mA (each color)
- Polarity: Refer to the Arrow on the Reverse Side
Package Contents:
- 1x 100pcs 0603 SMD LED Assortment
Bezoar
2025-08-27 13:14:45
I needed to replace two of four surface mount green LEDs that I knocked off a circuit board while opening a cordless massage gun to repair it. Fortunately, these were functionally identical to the original LEDs and the illuminated color matches perfectly in both color and brightness (they are very bright).The 0805 LEDs are tiny and are a bit tricky to manipulate. They are slightly magnetic and tend to cling to the steel tweezers I used to position them on the PCB. Fortunately, 60/40 solder readily adheres to them.
bikram kang
2025-08-20 16:41:35
These LED are great, used them to fix dead lights on my tach of various colors. They are very small so order a pair of tweezers to handle them as its very difficult to hold on to these and apply some solder.
mark tyson
2025-08-01 19:07:10
Used two white LEDs to fix backlighting LEDs burned out on my vehicle. No issues, and close match to the existing LEDs....
Renaissance
2025-07-03 16:24:08
Exactly what the description says. If you need 3528 surface mount LEDs these work. Tested on my bench power supply at 3V and the white ones draw about 0.011A each and are exactly as bright as I expected. Should be a bit more if you plan to drive them at a full 3.2 or 3.3V. The white color is a cooler white, which is exactly what I wanted (not sure on exact K value, but it's not a "warm white"), the other colors look your standard LED "pure" colors.
John
2025-05-24 15:49:41
These SMD LED's are very Tiny but they are bright and seem to work well for what I wanted. Just wish the leads were a little bigger for soldering.
GoBeavers
2025-05-20 10:40:26
Used as the indicators for my 3D Printer Prusa IR filament sensor. Very bright.
Chris
2025-01-07 13:00:55
I used these 1206's to replace all the switches and 4wd knob lights. I have to say they all look great! Every single LED I installed worked and were bright. Definitely recommend.
Richard Dlugosz
2024-12-30 15:47:31
I use these small light for making lighted greeting cards. They are just the right size to work with easily. They are very bright and colorful. Love using them!
Recommended Products
