Your cart is empty.
Your cart is empty. Extended shaft Brand new and high quality
This Pencil Polishing Brush is great to use for polishing and finishing step
Used widely in aerospace, plant maintenance, foundry, automotive, metal fabrication and shipyards
Wheel Brush Diameter: About 6.0 mm
Shank diameter: 3 mm
Package include:
10 * Stainless Steel Wire Brush
LBS4
2025-08-05 10:05:24
I bought these to clean up the fuel injector bores on an intake manifold, absolutely perfect! They fit in a Dremel collet & are a lot more sturdy than I thought they would be. Perfect for this application, also for cleaning up the manifold as well.
zDon Bry
2025-08-03 11:29:58
Awesome quality tool can be used for home, shop and sports maintenance. Thanks
Charles Jackson
2025-07-13 19:12:30
Look well made but I returned them because they are kind of small for what I needed them for.
Aaron
2025-05-25 15:34:42
Was really happy, used to clean out the abs tone rings after pulling out the abs sensors of my old rusty truck, worked great and didn't loose any brushes inside the hub that I could tell and cleaned off the rust. However remember these brushes aren't mentioned to last a life time and need replacing after heavy use but 2 brushes cleaned the rings considerably since I had the truck on Jack's and drove it while using these to clean.
slippery nickel
2025-03-31 17:58:52
If you need ones long and hard to detail a atv motor you will not want to invest or rather loose money on these but good enough quality to use on restoring tools that have rusted up so it’s a real toss up for light work these are to me a 5 star but for my true intent for these it didn’t work out that well!
pigwagon
2025-03-27 17:44:19
I bought these to scrub the battery acid off and out of devices where the acid leaked out of the duracell batteries which damaged my digital camera and my flashlights which worked
rick s.
2025-03-19 19:26:56
For years I struggled to get the carbon off of the inside of the BCG. Regular Dremel bits were too short. Drill bits were too large. I had to resort to wraping steel wool around a rod and soaking it with Hoppes. It took way too long to get it clean. These bits are perfect. Use on low speed, not high as they will tear themselves apart at max speed. Gently inserted until they hit bottom and in seconds the carbon is gone w/o damage to the chrome lining.
Jorge Roman Vega
2025-03-07 13:06:09
One use tool. Do the job in hard spaces but don expect much service
RAZR
2025-02-14 15:55:36
Would not attach them to a drill.
Yvon Laramee
2025-01-30 18:36:49
Work very well
Recommended Products
