Your cart is empty.
Your cart is empty. The 41F/0H41/SH41/SS41F/S41 is an integrated Hall effect latched sensor designed for electronic commutation of brush-less DC motor applications.
The device integrates a voltage regulator, reverse battery protection diode, Hall sensor with dynamic offset cancellation system, temperature compensation circuitry, small signal amplifier, Schmitt trigger and an open-collector output to sink up to 25 mA.
Package Including:
10pcs*41F/0H41/SH41/SS41F/S41
Shari A. Marcotte
2025-08-30 16:31:50
The motor on my Ehora AM100 stopped working. I replaced the bad Hall effect with this one and got the bike running again.
xfunkyflipx
2025-08-11 16:53:31
I used this to fix my 48v 750w bafang motor when the wire was over extended and shorted the hall sensors. Just replaced one and all is well so far.
Cheyanne
2025-08-04 14:14:45
Didnt come as described
Chewner
2025-05-30 10:30:31
I ordered these to replace the hall sensors on my RV slide motors, as they are a direct replacement. The shipping was fast and I got my bag of 10 right away, however, when I tested each sensor to make sure they were operational, I discovered that 4 of the 10 were bad (would not latch). Make sure you test them before permanent installation! I reported damaged items through Amazon and they are sending a replacement, at the expense of my debit card if I don't return the defective ones.
Timothy Stewart
2025-05-29 13:27:24
After having two hall sensors fail within a week of each other I bought these to replace the factory sensors in my Xiaomi M365 clone (Swagtron Swagger 5). Sensors came quickly and in an ESD bag. All three so far work right out of the package first try(luckily since I forgot to test before installing them). They also managed to survive longer than necessary expose to heat soak from the soldering iron as a result of difficulties of my own making. All in all I couldn't ask for more from these little guys.
Carl Lyons
2025-05-15 17:04:04
I installed one of these on my stealth bomber clone the code is gone but the wheel just stutter.guess I should have done more research
A. Myers
2025-03-23 18:19:28
120 pcb worked great finely got my 1000w e bike hub motor running!!! Supper stoked.. Got them fast and supper happy...Wish some one on Amazon would sell the PCB boards there is a lot of 1000w hub motors on here but no way to fix them if you need to...You can order PCB boards else where but I would rather not wait 2 months shipping and then worry about not even getting them or my money back!
David Benavidez
2025-01-18 17:27:36
I have a zero electrics scooter 48v my hub motor would not rotate it was stiff solid there was water damage Lots of rust and corosion cleaned everything with wd40 and my dremal tool and wire brush, still would budge just click then i checked the hall sensors with little refrigerator magnets took every thing apart resodered the hall sensors and the wires the surprise it worked
ISRAEL G
2025-01-10 11:33:41
Funcionan!
Recommended Products
