Your cart is empty.
Your cart is empty.Product Description
12inches(300mm) Hexagon handle (1/4 handle), 6.35mm (1/4 ") screwdriver head, High hardness, rugged, clear angle, easy to loose Flexible Drill Bit Extension bit holder.
Magnetic Extension Socket Drill Bit Holder
It can be bent, bent shaft, shell and soft rod separation. The shaft rotates only inside, and any point outside is not rotated.
Double Lock
The magnet is located inside the tube and there is a ball lock inside, securely holds the bits in place, reduces the possibility of wobble or fall out, ensures the accuracy of your power drill or other devices.
High hardness, rugged, clear angle, easy to loose Flexible Drill Bit Extension bit holder
It can be bent, bent shaft, shell and soft rod separation. The shaft rotates only inside, and any point outside is not rotated.
Use in hard to reach places and widely used
PL
2025-07-30 17:59:58
Strong, well made and engineered. Good value. Would buy again.
Deb
2025-07-02 09:42:06
Very flexible and great quality. Has been very useful at my job in the plumbing,Heating ,hvac industry.
John
2025-06-29 16:23:41
Only used once, so far, but seems to work as I had hoped it would. Price is for sure better than big box stores. Not a tool I will need everyday so nice to get it at a lower price.
Mark Perrenoud
2025-06-05 18:59:06
So, this was really good, for a time.It is flexible but sturdy.I have had right angle adapters break gears, but this doesn't have gears to break.However... the sleeve that covers it, designed for you to hold... while driving a screw in, it slide forward, got caught in the slip ring, and jammed the entire tool. It doesn't spin anymore. And the bit in it is stuck as the slip ring is stuck.All it needs is a little washer, built into the housing, to prevent the sleeve from sliding forward, that's it.Hopefully we see a version with that fixed.
Ed
2025-05-05 15:22:41
good product
John H
2025-02-13 12:47:12
Extenstion tool for difficult angles and locations.Top quick release pushes forward to release. when you hold this area to stabilize bit as it spins, it slides forward dropping bit out of tool...if you use the plastic rod below quick release, it slides forward becoming stuck and preventing the quick release from moving. I had to cut 1/2" of the plastic off to be able to use the tool again.Out ide of these the tool holds on to bits and is easy to change. the end bit stays in drill. angle of bend, length are good.Would I recommend this to anyone? NO. I would recommend you get a tool that is designed better.
MARK A. DESALVO
2025-01-27 13:38:40
Stronger than others I've had and covered shaft so you're not worried about grinding your hand holding on.
Jose montalvo
2025-01-07 18:57:46
It’s supposed to be flexible. It’s not flexible. If thing is hard like a rocket it doesn’t be.
Recommended Products