Your cart is empty.
Your cart is empty. Specifications:
Rated Voltage: 3V~12VDC
Motor Diameter: 27mm/1.06in
Pump Head Diameter: 44mm/1.73in
Length: 60mm/2.36in
Inlet/Outlet Diameter: 4mm/0.15in
. Head: 1.5M/4.9ft
Note:
1. Please do not connect it to 7.5V or higher voltage for a long time.
2. Single dry cell battery, mobile phone charger and other chargers can NOT be used as a power supply.
3. All power supply with a actual current less than 1.5A or actual voltage more than 12V can NOT be used otherwise the pump will not work or might burn out.
4. The pump is not a submersible pump, it can not be put in water.
5. No-load test time should not be too long.
6. Impurities in water should not be suck into the pump, so please make sure water is clean.
7. If pump is stuck, open the front cover and clean.
8. The input voltage is from 3V to 12V DC, terminal with red dot is the positive electrode.
Package Includes:
1 x Mini Pump
Customer #36884
June 9, 2025
Product is mislabeled. It's a gear pump, not a diaphragm pump as advertised. Doesn't match the description. I opened it up and its just two gears for the pump mechanism, there's no diaphragm.
Lexmoew7569
May 15, 2025
Not what I was thinking hard to figure out what size it is with out something to compare size to
Steve Harmon
April 25, 2025
Does it’s job
Jack of All Trades
April 10, 2025
Complete junk. Came poorly packed with the outlet port snapped off. Would not prime. Manually primed it by sucking on the output, pumping action was very weak. Smelled of burning plastic. Tried multiple voltages using a bench supply. Do not buy.
Customer
April 5, 2025
when i opened the box 1 pump was missing a nipplle plastic is junk supper slow shipping
John
April 2, 2025
Teaching my granddaughter how to use a pump.
Dan G Ghuudman
March 2, 2025
Amazing micropump. I drained out a dishwasher full of septic water left for over a month and this little pump sucked it dry and was asking for more, and I ran it off a old 9 volt battery . It just spun up to a rpm well over its redline and moved that stink water out of that old dishwasher for me so I could get in and repair it without sticking my hands into that swamp water. It will drain anything you hook up to its barbed fitting on the pump manifold and run its guts out without getting winded or burning out on you. If I had had one of these a few years back I wouldn't have got flesh eating disease in my left ring finger and almost lost it from a little cut on it getting infected because I stuck my hands into the filthy standing dishwasher water sitting there for who know how long before I arrived at the service call. Just don't be using it later to move your drinking water after you run stink water through its guts, I would say it is forever meant for dank liquids after you fo and do that.
Sir Spendalot
February 7, 2025
The motor shaft does not extend far enough into the pump housing . Because of this the end of shaft seats in the drive gear only by a 1/3 causing premature wear and failure.Tried very thin spacers in the motor to correct this but was not very successful as the brushes shorted on back of armature.Finally modified pump housing to allow it to seat lower and was successful.Decided to use another type of pump for my rc submarine that is higher quality.Pump housing is good but the motor shaft length is too short.This is a flawed design and don’t recommend unless you have patience to correct the issue.
Bob Robert
January 27, 2025
Update : If the pump does not work, take the cover off and add a bit of grease over and under the gears (take them off carefully). This fixed the problem of the three pumps i had (two were not pumping but it got fixed like that) Please try it before returning!!Good:It really is self priming up. its a made kinda like a root blower style, but with gears instead of rollers.If you get a working pump it's an awesome model.Cons:kind of a gamble really... i took 2 pumps, both running, one defective(not pumping and could not find the cause) and the other had a nipple broken. i took both to make one good working pump. also one had a jammed motor, but it free'd itself up after i gave it power.Once i got it to work, i ran it on 4.8-5v and is was not really impressive... Then i took it on 7.4v and the thing was insane! tho i believe it wont last too long at that power. so i dialed it back at 6v and its working great so far... for real!other:If you get a working pump it's an awesome model. Would recommend getting at least two to get at least one working one, or spare parts if needed.
Andy
January 26, 2025
Pump does run when I inject power to it. But there's no air coming out from either of the 2 ports. Have tried with various voltage range from 5 to 12 and nothing happened. Not sure what to do here. No direct instruction on how to operate thisWill return the item and ask for refund
Shopper S
December 20, 2024
Pump works well and able to pump water up from a lower height. I used it for a plant water project.
Recommended Products
