Your cart is empty.
Your cart is empty.Product Description
1/4" (dia.) Double Flute Straight Bit with 1/4" shank, 2-1/2" overall length
From the Manufacturer
Freud's precision ground carbide bits have a grain size smaller than other grades, and titanium is added making them impervious to chemical attack. Promoting safer woodworking is the reason Freud made a commitment to develop anti-kickback router bits. Bits are computer balanced to insure vibration-free operation at speeds that are a safe margin above the typical 22,000 RPMs of most routers. Freud's philosophy is woodworkers should expect safety, not pay for it. Cut diameter 1/4-inch, cut length 1-inch, shank diameter 1/4-inch.
KBS
2025-08-27 13:14:12
Performed well
Old carpenter
2025-08-04 14:43:40
Project changed, so haven't used this, but I know the brand and it's always excellent quality stuff.
JustMe
2025-07-09 18:28:49
I know pros that use this brand of bits. For DIY, some would consider these expensive. I use it in my introductory level CNC router, router table and my handheld routers. Sometimes a straight bit works best, especially in soft woods, ply, or MDF. It really works well with a router guide on the router table when working hard woods. There's a lot of information available on how to use routers safely in all wood types.This one is definitely worth the price.
Laptop
2025-06-20 11:23:52
Used bit in pine for dovetail work. Needed the longer shank for the dovetail jig. Clean cuts. Little to no splintering. Went slow. No concern about breaking. Cut 8 corners, did not overheat.
MO
2025-06-17 10:31:44
It is a very sharp and durable bit
Jennie Brinker
2025-05-31 17:36:21
Work great. Right size
Customer
2025-05-26 16:04:53
What I needed for a particular job.
vininger
2025-04-04 12:03:44
I purchased this for a CNC router. I measure all my endmills prior to using them and this one came in just shy of the stated 1/4." To me this is not an issue because I always enter the real diameter of the endmill into my CAM software. I have never found an endmill that has been exactly to specifications advertised, but I do not purchase $100+ endmills because for what I do, the software corrects for inaccuracies in the diameter. This endmill works great on hardwoods and plywood. I prefer the straight flute type for wood because I do not get any tear-out and this one leaves a nice clean finish. It also works great at cutting HDPE plastic.
Jordan Pinder
2025-03-16 11:54:49
Exactly what I was wanting. Good quality. Fair price
Jay
2025-03-14 14:57:48
A great bit for the price!
Andrew
2025-03-01 16:48:14
I was hesitant given other reviews, but I had no issue cleanly and quickly cutting a long, 7/8" deep slot in red oak, in only 3 passes.
Glynn
2025-02-11 10:56:24
Works greatbon hard wood. Best on the market.
Skye Kennedy
2025-01-06 14:40:05
Broke after only a few uses
Recommended Products
$82.31
$ 35 .99 $35.99