Your cart is empty.
Your cart is empty.2 Pack Flange Coupling Connector, Rigid Guide Steel Model Coupler Accessory, Shaft Axis Fittings for DIY RC Model Motors, High Hardness Coupling Connector-Silver. (2 pcs 8mm)
john covin
2025-09-04 10:00:21
These flange couplers are exactly what we needed for my 12v DC motor to drive the turntable I am building for my model train layout. I was surprised by the quality at the price offered.
Bob
2025-07-29 14:03:56
I'm in the process of designing and building a min carousel. My plan is to use one of these flanges to connect an 8mm brass rod serving as a drive shaft to one of the 15" diameter rotating surfaces. The expectation is that the shaft will pass completely through the flange and then be secured with the set screws. However, the flange does not maintain the full 8mm interior diameter all the way through. With about .001" left before the base of the flange is fully drilled through, leaving the diameter of the hole at the base of the flange just shy of the full 8mm width. The brass rod is very cleanly cut, but i just tried an easier alternative to trying to file or redrill the hardened steel flange. I took the rod, pressed the end again the flange hole at the base and forcefully turned it. Whopee. Apparently the end of the shaft was a tiny bit flared at the cut because now the shaft easily pushes through the flange. I'm overjoyed!
B. Miller
2025-07-17 13:22:30
Just be aware the mounting holes are not threaded, and are drilled about 2 degrees off rotation versus the threaded hole in the shaft. This probably won't affect 99.9% of applications.
Jeff Noyes
2025-05-02 11:41:46
I'd buy again in a second.
G Force X10
2025-04-14 14:02:46
The four holes had to be tapped. The rest is good.
Tim Selner
2025-04-04 10:48:22
This is the only place I could find these parts. Just what I needed!
D.B.
2025-01-12 11:50:30
seems ro be substantial enough for my purposes, but was a little annoyed when I noticed the holes aren’t threaded. not a huge deal to tap them yourself if you don’t have clearance for a nut but still
Roger Bertrand
2024-11-23 15:30:50
Worked exactly what I needed it for.
Recommended Products
