Your cart is empty.
Your cart is empty.Product Description
Performance:
- Adhesion: 8N/25MM
- Tensile strength: 135N/25MM
- Elongation at break: 60%
- Withstand voltage: 6KV
- temperature : short-term temperature 250°C, long-term temperature 200°C
Main Application:
- High temperature protection
- Insulation / Lithium battery extremely car fixed
- Transform coil wrapping and fixed
- Chip insetting
- 3D printer
Tom
2025-08-24 16:46:06
This tape works just as it should.
Scott
2025-08-23 11:15:26
Use at 300 degrees, Cerakote. No issues.
Michael D.
2025-08-06 09:31:40
Works best it it goes all the way across the patch.
Eric
2025-08-02 18:05:11
Works well during application. Easy to cut, adequately stiff, good adhesion but reworkable if needed. Withstood powder coat baking at 390-400 F for 15 minutes and was easily removed after. Happy with this and will buy again when I run out.
Customer
2025-07-12 11:30:58
Easy to work with and definitely handles the heat.
Iggnator
2025-05-27 14:14:09
I used this tape to cover over the hole on a brake slave cylinder. I used a gasket hole punch to make a round 'dot'. It stayed in place during the powder application, and during the oven cure. Too bad you can't see how pretty the brakes are under the drum, but the intent was long term corrosion resistance.
Stacey W
2025-04-22 10:07:53
Exactly what I needed. Will buy again!
Joel
2025-04-09 12:58:45
Everything was great about just not the adhesion. In my case wasn’t a big deal but for someone who needs a strong adhesive bond you probably won’t be happy with this product.
Aaron C.
2025-02-09 18:17:56
Looks good
Recommended Products