Shopping Cart

Your cart is empty.

Your cart is empty.

200Pcs/50 Sets Pegboard Mounting spacers and Screws Kit Contains Screws, Spacers,Washers and Lock Clip, Peg Boards Installation Hardware Accessories for 1/8' & 1/4' Pegboard

4.8 (2) Write Review
Free shipping on orders over $29.99

$14.96

$ 7 .99 $7.99

In Stock

About this item

  • Package Includes: The 200pcs/50 sets pegboard spacers mounting kit contains 50pcs zinc plated screws, 50pcs lock clips, 50pcs stainless steel flat washers, 40pcs rubber spacer. Enough quantity will meet your daily use and replacement needs.
  • Size Information: Widely applied to most standard sizes of pegboards. Ideal for 1/4 inch and 1/8 inch pegboard (thickness not exceeding 1/4 inch) The length of the screw is 2 inch / 50mm, the depth of the gasket is 0.48 inch / 12mm, and the diameter of the gasket is 0.4 inch / 10mm. (Please check the size before purchasing).
  • Durable Material: The screws and flat spacers are made of high-standard stainless steel, rust and corrosion resistant to ensure a long service life. The spacers are made of ABS plastic, which the spacers rigid enough to prevent bowing. After the whole set is assembled, it stays securely mounted over time even if it is used frequently, offering a secure and stable mounting, suitable for heavy-duty applications.
  • Easy to Install: Our pegboard mounting accessories are easy to install. Installation requires only a screwdriver and level, power screwdriver recommended. (not included). The 2 inch wood screw length is designed to pass through a wide range of materials; the included washers prevent scratches on pegboards; includes lock clips and rubber spacer that help secure pegboard mounts;
  • Essential Pegboard Accessories: Perfect for mounting a pegboard to the wall. The peg boards installation hardware accessories can be applied for mount pegboard on wood stud, drywall, hollow slabs and concrete walls. Useful storage solutions for your garage, craft room, laundry room, retail store or office


Yauhar 200Pcs/50 Sets Pegboard Mounting spacers and Screws Kit Contains Screws, Spacers,Washers and Lock Clip, Peg Boards Installation Hardware Accessories for 1/8" & 1/4" Pegboard


HandymanGeek
2025-05-16 15:55:57
Installing the pegboard became a challenge because the lock clicks on the back side betweent the spacer and the wall did not stay on the end of the screw. I had to remove the pegboard more than once during the installation because one, usually more, lock clips fell off.After the screws are installed, the spacing away from the wall is good and the pegboard is secure - as long as the screws are secured into a wall stud.If the lock clips worked like they should and didn't fall off during installation, they would get a 4-5 star rating.
Mike
2025-02-08 18:37:51
The lock clips won't stay on the screws, that makes for a very frustrating installation. I tried hammering them flat and it helped a little but they still fell off quickly followed by the spacer. It's not too bad on the edges if you have access to them but in the middle if one falls off you have to start over again. Another issue is the screws that are provided. They need to be self tapping torx head. It's almost impossible to start them into a stud without a pilot hole which would add an extremely complicated step to an already difficult process